AUDIOLINE STUDIO 60 Datasheet

Sub20 active subwoofer

Operation manual / Bedienungsanleitung

english / deutsch

2

Introduction

First of all, we would like to thank you for choosing ADAM Audio!

ADAM Studio Subwoofers are built to a maximum in reproduction quality and perfection. To

enjoy the capabilties of your new subwoofer please read the following hints and considera-

tions, as the positioning and the acoustical properties of the control room often play a bigger

role than you might think.

General recommendations for the Setup:

• Thesubwoofershouldbepositionedonarmground.Vibratingpartscanmaskthesound;

there is not necessarily a clear distortion to be heard.

• Itisrecommendedtopositionthesubwooferbetweenthefrontspeakers,ifpossiblewith

a minimum distance of 20cm to the back wall.

• Avoidtopositionthesubwooferinacorner.Due toa resultingphysicalpeakin the

frequency response there will always be a tendency for resonances and boominess.

Transportation

Ifyouhavetosendyoursubwoofertoanyotherlocationitisofvitalinteresttohavethe

originalpackagingmaterials.Experienceshowsthatitisverydifculttoavoiddamagesif

youhavetosendthemwithoutthesematerials.Wewillnotberesponsiblefordamagesdue

to improper packaging.

Wehopeverymuchthatyouenjoyyournewsubwooferanditsuniquesoniccapabilities.If

therearequestionspleasedonothesitatetocontactus-wewillbehappytoadviceyou.

The ADAM people.

Table of contents

SafetyInstructions 3

Quick Start 4

Controls ans Connectors 5-7

Limited warranty 8

Technical Data 9

English

3

Safety Instructions

Incaseofaproblem,pleaseeithercontactyourADAMdealerorus.Wearehappytotryand

help.Alwaysreferservicingtoqualiedpersonnelandneverattempttorepairthisproduct

by yourself. Please read through the following safety instructions completely before setting

your system up.

• Donotopenthesubwoofer.Therearenouser-serviceablepartsinside.

• Donotexposethisproducttorainormoisture,neverwettheinsidewith

 anyliquidandneverpourorspillliquidsdirectlyontothisunit.

• Neveruseammableorcombustiblechemicalsforcleaningaudio

components

• Avoidtouchingthespeakermembranesanddonotblockthewoofer’s

 ventilationports.

• Assurefreeairowbehindthespeakerstomaintainsufcientcooling.

• Alwaysusefullycheckedcables.Defectivecablescanharmyourspeakers.

They are a common source for any kind of noise, hum, crackling etc.

• Alwaysswitchoffyourentiresystembeforeconnectingordisconnecting

any cables, or when cleaning any components.

• Thisproduct,aswellasallattachedextensioncords,mustbeterminated

 withanearthgroundthree-conductorACmainspowercord.Toprevent

shock hazard, all three components must always be used.

• Neverreplaceanyfusewithavalueortypeotherthanthosespecied.

 Neverbypassanyfuse.

• Neverexposethisproducttoextremelyhighorlowtemperatures

• Neveroperatethisproductinanexplosiveatmosphere.

• Alwayskeepelectricalequipmentoutofthereachofchildren.

• Alwaysunplugsensitiveelectronicequipmentduringlightningstorms.

4

Quick Start

•After having unpacked your subwoofer, please allow the system to acclimate to the

temperature of the room. Please do not connect the subwoofer for approximately an

hour.

•Makesurethepowerswitchatthecontrolpanelisturnedoff.

•Decrease the volume of your audio system to protect your speaker and ears from

damage when switching the system on.

•Connecttheprovidedpowercordtothesubwoofer.

•Connectthesubwooferwithyou’reaudiosystemviaXLR(1)-orChinchinput(2).

•Switchpoweronatthecontrolpanel.Byincreasingthevolumefromyouraudiosys-

tem, you should now hear sound.

•Toachievethebestpossiblesoundreproduction,pleaseseethefollowingconsidera-

tions for speaker placement.

(1) (2)

English

5

Mode

ThispushbuttongivesachoicebetweenSignal On: woofer starts operation as

soonasamusicalsignalarrives,andstopsafter15minuteswithoutasignal.

Continuous: the unit is always working.

Werecommendthe”Signalon”positionthatminimisespowerconsumptionandhasproved

to be practical that way as you do not need to look for the main power switch any more.

Phase Switch

WiththePhaseswitchyoucanalterthephaseoftheSub20relativetothesatel-

lites. Practically it means you change the polarity of the bass unit. Depending on

thedistancebetweenwooferandsatellites0°or180°maybethebetterposition.Thereis

no“right”or“wrong”position,youhavetondoutbyyourselfwhatsoundsbetter,more

exactlyandmorehomogeneousinthelowend.IfyourepositiontheSubwooferyouneed

to repeat the procedure.

Controls and Connectors

6

Satellite Filter

Thesatellitesinsuchasystemcanbedrivenfullrangeorwitha85Hzhighpassas

recommended by Dolby® laboratories for use in surround setups. Recommenda-

tion:IfpossiblegowiththemainsignaltotheSub20rstandconnectyoursatellitestothe

Sub20output,beitXLRsymmetricalorRCAasymmetrical.Topreventthesatellitesfrom

the low frequencies in most cases leads to a better sound from your satellites, as they do

nothavetodeliverthebigamplitudes.Oftenclarityanddynamicrangeofthesespeakers

areimprovedthatway.

Attention! If you switch the ﬁlter in or out, it often becomes necessary to switch the

phase as well - try it out please!

Sub Level:

InputSensitivitycontrolfrom-60dBto+6dBrelativeto775mVwhenusedvia

thesymmetricalXLRinputorrelativeto250mVwhenusedviatheasymmetrical

Cinch(RCA)input.

Sub Filter:

Theupperfrequencylimitoftheunitisvariableandcanbesettoanyvalue

between50and150Hz.The85Hzmarkerindicatestherecommendationof

Dolby®labsforsurroundsoundsettings.Inpracticeaslightlylowercrossover

frequencydeliverstighterbassresponse,fortypicalnear-mideldmonitorswerecommend

a12or11clockposition,meaning70to75Hzasupperlimitor,tobemoreexact,-3dBpoint

in the frequency response.

Pleasenote:thesesettingsdonothaveaprecisecharacter,asdifferentsatellitesanddifferent

roomacousticsleadtoresultsthatcannotbeforeseen.Inthemajorityofcasesthereisthe

dangerofboominess,ifyoutakethesamesay85Hzforboththesatelliteandthesubwoofer.

Somewhatsmallervaluesforthesubleadtotighterandbettercontrolledbassresponse.

Controls and Connectors

English

7

Sub Out

This a symmetrical and buffered output representing the input signal. This en-

ablesyoutochainasmanySub20inarowasyoulike.TheSubLeveleffectsthe

output,sothatallpossiblechainmemberscanbelevelledatatime.Insteadof

oneverybigsubwooferitoftenisbettertohave2smalleronestoavoidstandingwavesat

verylowfrequencies.Thisalwaysmeansalittlebitoftesting,asitisnotpossibletopredict

thebehaviourofasubwooferinunknownacousticalconditions.

Input - Balanced and Unbalanced

Thesestereojacks-XLRinthebalanced(alsonamed:symmetri-

cal),CinchorRCAintheunbalanced(alsonamed:asymmetrical)

case, should be connected to the output of your mixing console

or stereo/surround sound system.

Satellite out - Balanced and Unbalanced

Thesejacksshouldbeconnectedtotheinputsofyouractive

studiomonitorsortheinputsofapowerampthatdrivespas-

sivemonitors.Thesignalissimultaneouslyavailablefromall

connectors.

Final recommendation:

After using the set up a few times we recommend to test the position of the controls again.

Inmostcases,whentheexcitementaboutthenewbottomhasbecomeless,youprefera

solutionwithlessbasslevel,andfromourexperiencethiswillbethemorecorrectone.

Controls and Connectors

8

d)

a)

b)

c)

e)

Warranty

ADAMAudioGmbHprovidesaﬁve year limited warranty for this product.

Terms and Conditions

This warranty is limited to the repair of the equipment or, if necessary, the

replacement of parts or the product and return shipping within the country

of purchase.

This warranty complements any national/regional law obligations of deal-

ers or national distributors and does not affect your statutory rights as a

customer.

Neitherothertransportation,noranyothercosts,noranyriskforremoval,

transportationandinstallationofproductsiscoveredbythiswarranty.

Productswhoseserialnumberhavebeenaltered,deleted,removedormade

illegible are excluded from this warranty.

The warranty will not be applicable in cases other than defects in materials

and/or workmanship at the time of purchase and will not be applicable:

for damages caused by incorrect installation, connection or packing,

for damages caused by any use other than correct use described in the user

manual,

for damages caused by faulty or unsuitable ancillary equipment,

ifrepairsormodicationshavebeenexecutedbyanunauthorizedperson,

fordamagescausedbyaccidents,lightning,water,reheat,publicdistur-

bances or any other cause beyond the reasonable control of ADAM Audio.

How to claim repairs under warranty

Shouldserviceberequired,pleasecontact the ADAM Audio dealer where

the product has been purchased.

Iftheequipmentisbeingusedoutsidethecountryofpurchase,theinterna-

tionalshippingcostshavetobepaidforbytheowneroftheproduct.

ServicemaybesuppliedbyyourADAMAudionationaldistributorinthecoun-

tryofresidence.Inthiscase,theservicecostshavetobepaidforbythe

owner of the product whereas the costs for parts to be repaired or replaced

arefreeofcharge.Pleasevisitourwebsitetogetthecontactdetailsofyour

local distributor.

Tovalidateyourwarranty,youwillneedacopyofyouroriginalsalesinvoice

with the date of purchase.

English

9

Technical Data

Technical data Sub20

Woofer 2

Basketø 10“/260mm

Voicecoilø 2“ / 50 mm

Cone Material Coated Paper

BuiltinampsRMS/Music

*1/2

2x200W/300W

Frequency response 25Hz-150Hz

THD>60Hz ≤1%

MaximumpeakSPLin1mhalfspace ≥118dB

Crossoverfrequencies 50-150Hz

Inputconnectors XLR/ RCA

Inputimpedance 10kΩ

Weight 38kg/83.8lb.

Magnetically shielded no

Heightxwidthxdepth 22“x32“x12“/560x810x300mm

Warranty 5 years

*1 = long term IEC 265-8-Wrms / 10 min

*2 = nominal IEC 265-8 = Peak Power 5 µsec

Page is loading ...

Sub20Manual/Bedienungsanleitung.Version03.2009English/deutsch.

All data subject to change without prior notice.

ÄnderungdertechnischenDatenohneVorankündigungvorbehalten.

ADAM Audio GmbH |Ederstr.16 |12059Berlin |GERMANY

tel:+4930-8630097-0|fax:+4930-8630097-7 | email: [email protected]

ADAM Audio UK Ltd. | email: uk[email protected]

ADAM Audio USA Inc. | email: usa-inf[email protected]

www.adam-audio.com

VisitusonFacebook | Follow us on Twitter

AUDIOLINE STUDIO 60 Datasheet

AUDIOLINE STUDIO 60 Datasheet

in other languages

Other documents