2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Cloud
  6. CS-SUB8

Cloud CS-SUB8 User manual

  • Hello! I am an AI chatbot trained to assist you with the Cloud CS-SUB8 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CS-SUB8 Installation Guide V1.0
CS-SUB8
8” Surface Mount Subwoofer
Installation Guide
CS-SUB8 Installation Guide V1.02
CAUTION - Installation
Speaker must be installed by qualied speaker technician.
CAUTION - Servicing
Do not perform servicing unless you are qualied to do so. The unit contains no user-serviceable parts.
Refer servicing to qualied personnel.
CAUTION - Tap Switch
Before use check and set tap switch under grille to proper setting for your system.
EXPLODED VIEW
Grille
Feet(4x)
Wall Bracket
Speaker Mounting Bracket
Mounting Bracket
Screw holes
Euro Block
Wall Bracket Mounting Tab
Bracket Locking Screw
Tap Switch
Bracket
Screws(4x)
TAP SETTINGS
Ta p
CS-SUB8
100 V 70 V 25 V
1 4 ohm
2 X 100W 13W
3 100W 50W 7W
4 50W 25W 3W
5 25W 13W 1.5W
6 13W 6W 0.8W
CS-SUB8 Installation Guide V1.0 3
INSTALLATION
Step 1
Remove speaker from box.
Step 2
Locate euroblock in accessory bag and connect signal wire.
For daisy chaining, use “LINK” output to run to next speaker.
Step 3
Set tap switch to proper setting. Tap switch is preset to highest
100V position.
Step 4 - SURFACE MOUNT
Remove rubber feet. Attach speaker mounting bracket to
cabinet choosing vertical or horizontal mounting holes with
provided screws, DO NOT OVER-TIGHTEN.
MOUNTING OPTIONS
Floor or Shelf
Horizontal
Surface mount
Vertical
Surface mount
Fly mount
CS-SUB8 Installation Guide V1.04
Step 4.1 - Horizontal
Use these hole to attach speaker mounting brackets to
cabinet for Horizontal mount.
Step 4.1 - Vertical
Use these hole to attach speaker mounting brackets to
cabinet for vertical mount.
Step 5
Securely attach wall bracket with wall bracket lock tab facing
up.
Step 6
Insert euroblock into rear of subwoofer.
Step 7
Hang subwoofer by inserting tabs of speaker brackets into
wall bracket slots.
Step 8
Insert bracket locking screw at top of bracket.
CS-SUB8 Installation Guide V1.0 5
Step 9
Done.
FLOOR OR SHELF MOUNT
Follow steps 1-3. Set subwoofer on oor
or shelf.
FLY MOUNT
Insert 4 optional forged eyebolts in M6 inserts on side of
speaker cabinet. Use appropriate cables to hang speaker.
Follow steps 1-3.
CS-SUB8 Installation Guide V1.06
www.cloud.co.uk www.cloudusa.pro
/