Shenzhen BEBTIE028 True Wireless Earbuds User manual

Brand: Shenzhen

Model: BEBTIE028 True Wireless Earbuds

Type: User manual

Shenzhen BEBTIE028 True Wireless Earbuds offer a seamless audio experience with Bluetooth 5.0 connectivity and high-quality sound. Enjoy up to 4 hours of playtime on a single charge, and extend it up to 12 hours with the included charging case. Activate Siri or Google Assistant with a simple touch, and make or receive calls hands-free. Listen to music, adjust volume, or skip tracks with intuitive touch controls. Experience exceptional sound quality with 20-20000Hz frequency response and 32Ω impedance.

BEBTIE028 使用说明书

真无线蓝牙耳机

产品示意图

包装明细

蓝牙耳机 2个

耳机充电盒 1个

USB 充电线 1条

使用说明书 1份

精美包装盒 1个

产品规格

耳机配对名：BEBTIE028

蓝牙版本:V5.0+EDR

电源：输入 DC 5V1A / 输出 OUTPUT 5V1A

电池容量: 耳机 40mAh / 充电盒 300mAh

工作时间: 耳机单次使用约 4小时，充电盒可充约 3次.

充电时间：1小时

支持协议: HSP/HFP/A2DP/AVRCP

频率响应：20-20000Hz

阻抗：32Ω

备注：

为了客户更好的使用体验，新品首次使用建议预先充电 30 分钟.

产品说明

一.耳机蓝牙配对方式

两个耳机同时从充电盒拿起，耳机自动开机指示蓝灯闪烁，大约 1-2 秒后左右耳机红蓝

灯交替慢闪，语音提示“Pairing”即双耳配对成功.

从手机蓝牙列表中找到对应的蓝牙名 “BEBTIE028” 点击连接等待配对，约 3 秒语音提示

连接成功.

再次为同一台手机使用时，耳机开机后会自动按上一次配对好的自行连接.

用其他手机使用，重复以上操作.

二.充电状态

充电盒充电时红灯常亮，充满后蓝灯常亮

当充电盒为耳机充电时，充电盒红灯常亮，耳机亮红灯，充满后耳机和充电盒灯熄灭。

三. 关机

触摸耳机功能键约 5秒，耳机红灯闪烁 3次语音提示“power off”耳机关机. 如耳机未连接

电子设备，5分钟后将自动关机.

四.通话功能

当耳机开机并与手机连接，可接打电话.

当来电时，语音提示来电号码，触摸单次耳机功能键，可接听电话，触摸功能键 2秒则拒接

来电。

电话中，单次触摸功能键，将挂断电话，回到之前的状态，电话过程中，可通过手机调节通

话音量.

触摸三次耳机功能键，末号重播.

五.语音助手

触摸约 1秒左耳或右耳功能键，听到提示音“嘟嘟”一声松手，唤醒 Siri 功能.

六. 音乐功能

耳机开机状态与手机连接，可用耳机听音乐.

在音乐过程中触摸单次耳机功能键，音乐暂停，再次触摸功能键将继续播放音乐.

触摸 2次右耳功能键播放下一曲音乐，触摸 2次左耳功能键播放上一曲.

七.使用注意事项

1. 耳机需存放在干燥通风的环境下，避免与油、水汽、蒸汽、湿气和灰尘等接触，以免影响

产品性能。

2. 避免使用刺激的，有机溶剂或含有这些成分的物品清洁耳机。

3. 耳机需要按正确的规范使用，注意使用环境对耳机的影响，为保证连接顺畅，建议手机与

耳机之间的距离在 10 米范围内。

4. 如耳机有连接不上或通讯不畅等其他问题：请勿私自拆卸耳机本体及其配件，否则不予保

修。

5. 給耳机充电，请选用标配的充电器或本公司指定的符合要求的充电器。

6.为保证您正常使用耳机，请确保耳机的电量充足。

User's Manual

True Wireless Earbuds

Product schematic diagram

.Package list

Wireless earphones 2PCS

Charging case 1PCS

USB cable 1PCS

User Manual 1PCS

Packing box 1PCS

Wearing schematic 1PCS

Product specifications

Headset pairing Name: BEBTIE028

Bluetooth version: V5.0 + EDR

Power supply: input DC 5v1A / output 5v1A

Battery capacity: headset 40mAh / charging box 300mah

Working time: the headset can be used for about 4 hours at a time, and the charging box can be

charged for about 3 times

Charging time: 1 hour

Support protocol: HSP / HFP / A2DP / AVRCP

Frequency response: 20-20000hz

Impedance: 32 Ω

Remarks:

For the first use, it is recommended to charge the product for 30 minutes

Products use

1. Bluetooth pairing

The two earphones are picked up from the charging box at the same time, the earphones are

automatically turned on, and the indicator light flashes red and blue. After about 1-2 seconds,

the red and blue lights of the two earphones alternately flash slowly, and the voice prompt

"pairing" means that the pairing of the two ears is successful

Find the corresponding Bluetooth name "BEBTIE028" in the Bluetooth list of the mobile phone,

click Connect to wait for pairing, and the voice prompts that the connection is successful for

about 3 seconds

When the headset is used for the same mobile phone again, it will automatically press the last

paired connection

Use other mobile phones, repeat the above operations

2、 State of charge

The red light is always on when the charging box is charging, and the blue light is always on

when it is full

When the charging box is charging the headset, the red light of the charging box is always

on, the red light of the headset is on, and the lights of the headset and the charging box

are off when the headset is full.

3、 Call function

Touch the headset function key for about 5 seconds, the red light of the headset flashes 3 times

and the voice prompts "power off" the headset turns off. If the headset is not connected to an

electronic device, it will turn off automatically after 5 minutes

4. Call

When the headset is turned on and connected to the mobile phone, you can receive and make

calls

When calling, voice prompts the calling number, touch the function key of single headset to

answer the call, and touch the function key for 2 seconds to reject the call.

In the phone, a single touch of the function key will hang up the phone and return to the

previous state. During the phone call, you can adjust the call volume through the mobile phone

Touch the headset function key three times and replay the last number

5、 Voice assistant

Touch the left ear or right ear function key for about 1 second, and hear the prompt tone "beep"

to release the hand and wake up“ Sir”i function

6. Listen to music

The headset is connected to the phone when it is turned on. You can use the headset to listen to

music.

In the process of music, press the headset function key briefly to pause the music, and press

again to continue playing the music.

Double click the right ear function key to play the next music, double click the left ear function

key to play the previous music

7.Precautions

1. The earphones should be stored in a dry and ventilated environment.Keep it away from

oil,water,steam,moisture and dust to avoid affecting product performance.

2. Do not clean this product with any detergent containing chemical element or other liquid.

3. Please use earphones according to the correct specifications, Pay attention to the influence

of environment on earphones. It is recommended that the distance between the mobile

phone and earphones be within 10 meters to ensure a smooth connection.

4. If the earphones failed to connect or with poor communication or other problems, please do

not disassemble earphones body and its accessories by yourself, otherwise you will lose the

right to warranty.

5. Please use the standard car charger or the charger specified by the company to charge the

eraphones.

6. To ensure normal use, Please make sure the earphonesare fully charged

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment. This equipment has been tested and found to

comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

‐‐ Reorient or relocate the receiving antenna.

‐‐ Increase the separation between the equipment and receiver.

‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

‐‐ Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

The device has been evaluated to meet general RF exposure requirement.

Shenzhen BEBTIE028 True Wireless Earbuds User manual

Shenzhen BEBTIE028 True Wireless Earbuds User manual

Shenzhen BEBTIE028 True Wireless Earbuds User manual

Other documents