2. ekwb
  3. EK-UNI RAD Holder 140

ekwb EK-UNI RAD Holder 140 Installation guide

  • Hello! I've analyzed the provided installation manual for EK-UNI RAD Holders, focusing on the UNI 140 model. This document details mounting procedures, use as spacers, fan masks, and important safety considerations to avoid damaging the radiator. I'm ready to answer your questions about the product and its installation process.
  • Who should install this product?
    What could happen if installed incorrectly?
    What is used to make a distance from the case with radiator?
    What should be checked when mounting the radiator with screws?
Released on 9th of February, 2011.
Installation and mounting manual for EK-UNI RAD Holders
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before
installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
STEP 1: GENERAL INFORMATION. Sample picture of mounted radiator with EK-UNI RAD Holder
STEP 2: PREPARING YOUR PC CASE.
1. Open side panel of your computer case.
Remove the fan or fans if there are any installed on the inside on
the case.
STEP 2 cont.: Possible mounting positions of radiator with EK-UNI RAD Holders
Pictures 1, 2,3: A single 140mm radiator mounted on the back of the case with single 140 UNI RAD Holder as a spacer.
Pictures 4 & 5: A single 140mm radiator mounted on the back of the case with single 140 UNI RAD Holder as a spacer and as a mask for FAN.
Pictures 6 and 7: A triple 420 radiator mounted on the top of the case with single 140 UNI RAD Holder as a spacer.
RAD Holders
Radiator
FAN
4 × M3×60mm
screws
Radiator
FAN
4 × M3×60mm
screws
RAD Holders
as spacers
RAD Holders
as FAN mask
Radiator
3 × FANS
4 × M3×60mm
screws
RAD Holders
as spacers
M3×30mm
screws
Released on 9th of February, 2011.
philips screwdriver
Picture 10: Installing the radiator using 4 plastic Standoffs
Picture 11: Needed tools
STEP 3: Some sketches of possible application of EK-UNI RAD Holders
CAUTION!!!
When mounting the radiator with screws, always make sure the screws are not too long. Using too long screws may cause the
screws to penetrate too deep into radiator, damaging the radiator tubes, rendering it useless.
USING STANDOFFS:
Standoffs are used to
make a distance from
the case and the
radiator holder so the
side panel can close
properly on some
smaller cases.
4 × standoffs
Radiator
FAN
RAD Holders
/