2. Rugged Ridge
  3. 11585.25

Rugged Ridge 11585.25 Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge Tag Relocation Bracket JL. This document details the components and steps required to relocate your license plate on a JL vehicle, including securing the spare tire and adjusting the tag mount. I'm ready to answer any specific questions you may have about this bracket or the installation process.
  • What components are included with the Tag Relocation Bracket?
    How does the spare tire remain secured?
    How do I adjust the tag mount position?
Copyright © 2019 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 844-270-0593 | www.Omix-ADA.com
Rugged Ridge Tag Relocation Bracket, JL
Page 1/2
Part #11585.25
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]
Components
1. Tag Mount ................................................................................. 1
2. Lug Nut Bracket ........................................................................ 1
3. Lug Nut Extension ..................................................................... 2
4. M8 Black Button Head Screw ................................................. 2
5. M8 Black Flat Washer ............................................................... 2
6. M6 Black Button Head Screw ................................................. 6
7. M6 Black Flat Washer ............................................................. 12
8. M6 Black Serrated Flange Nut ................................................ 6
Tag Mount
Lug Nut Bracket
Extension
M8 Hardware
M6 Hardware
Copyright © 2019 Omix-Ada®, Inc.
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 844-270-0593 | www.Omix-ADA.com
Rugged Ridge Tag Relocation Bracket, JL
Page 2/2
Part #11585.25
2. Now attach the tag mount to the lug nut bracket
using the M6 hardware. It requires a washer on either
side of the brackets and serrated ange nut, see
gure A. This bracket has slotted holes to adjust the
tag mount away from your spare. Make sure there
is enough space from the mount and your spare to
avoid rubbing the nish of your spare.
Now install your tag with the provided M6 hardware,
see gure B.
1. The spare tire is secured by three lug nuts to the
tailgate bracket. Remove the two at the top one at
a time and replace with our lug nut extension. Fully
tighten the lug nut extension to secure spare tire.
Now install the lug nut bracket to the extensions using
the M8 screw and washer. Fully tighten.
3. We would highly advise adding a set of Rugged
Ridge LED License Plate Bolts (11233.10) to the tag
bracket to illuminate your plate and keep within your
local laws.
Lug Nut Bracket
Extension
Secures tire to
tailgate tire carrier
M8 Hardware
Figure A Figure B
/