Chief LC-1 User manual

Category
Cable locks
Type
User manual

This manual is also suitable for

CHIEF MANUFACTURING INC. 8810-000010 (Rev. A)
1-800-582-6480 952-894-6280 FAX 952-894-6918 ©2005 Chief Manufacturing
8401 EAGLE CREEK PARKWAY, STE. 700 www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 10/05
INSTALLATION INSTRUCTIONS
CABLE LOCK KIT
LC-1 & LC-1-12
The cable lock kit is used as a projector accessory. The kit
includes a coiled cable that extends to the applicable
length, two steel security pads, a 2-gram tube of super glue
gel, and a 30mm padlock.
The cable lock kit is supplied in two models numbers:
LC-1
Coiled cable, extends six feet.
LC-1-12
Coiled cable, extends 12 feet.
PARTS
Figure 1. Parts
PARTS LIST
Unpack the shipping carton and check for the contents
listed in Table 1 and shown in Figure 1.
Table 1. Parts List
LC-1 LC-1-12
REF DESCRIPTION QTY QTY
10A COILED CABLE, 6 feet 1
10B COILED CABLE, 12 feet 1
20 SECURITY PADS, steel 2 2
30 SUPER GLUE GEL, 2-grams 1 1
40 PADLOCK, 30mm 1 1
50 KEY, padlock 2 2
60 PREP PAD, Alcohol 1 1
INSTALLATION
To install the coiled cable (10A or 10B), do the following:
1. Locate the two flat surfaces where the security pads
(20) will be installed.
2. Clean the two flat surfaces using the alcohol prep pad
(60).
WARNING: Before using the super glue gel, read
the printed instructions on the tube carefully to avoid
personal injury.
3. Apply super glue gel (30) onto the cleaned flat surface
where the first security pad (20) will be placed.
4. Place the security pad (20) onto the cleaned surface.
5. Apply pressure onto the pad, as needed.
6. Repeat Steps 3 through 5 to install the second security
pad (20).
7. Connect coiled cable (10A or 10B) to security pad
(20) using the padlock (40). Retain the keys (50).
20
30
10A O
R
10B
40
50
60
20
  • Page 1 1

Chief LC-1 User manual

Category
Cable locks
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI