Dakota Digital VHX-69P-GTO Mounting Manual

Hello! I am an AI chatbot trained to assist you with the Dakota Digital VHX-69P-GTO Mounting Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Manual # 650514A

VHX-69P-GTO

Dakota Digital VHX Instrument Installation

For 1969 GTO’s

Your new VHX-69P-GTO kit includes:

Installation

Control Box

36” CAT5 Cable

Universal Sender

Pack

Installation Manuals

VHX Display

12” CAT5

Cable

1. Disconnect and remove the stock gauges from the dash and save all hardware for reassembly.

Switch Assembly

Manual # 650514A

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

3. Connect one end of the 12” CAT5 cable to either

jack on the Tach and the other end to the Speed

assembly, then connect one end of the 36” CAT5

cable to the remaining open jack on the Tach.

Use caution when routing the other end of this

cable to the control box mounting location.

2. With the stock gauges removed, the dash is now ready to accept the VHX gauges using stock

hardware in the seven (7) original mounting points.

4. Refer to the main manual for wiring

instructions to complete the VHX

installation.