Dakota Digital VHX-51C Mounting Manual

Manual # 650498A

VHX-51C

Dakota Digital VHX Instrument Installation

For 1951-52 Chevrolet Car

Your new VHX-51C kit includes:

Installation

Control Box

(2) CAT5 Cable

Universal Sender Pack

Installation Manuals

VHX Displays

1. Remove the stock gauges from the dash by removing the six (6) nuts from the backside of the dash

and retain the hardware for reassembly.

Manual # 650498A

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

3. Connect a CAT5 cable to the back

of each VHX gauges and take care

when routing the other ends to the

control box mounting location.

2. The VHX system is a direct

replacement of the original cluster, so

use the three mounting studs for each

gauge along with the factory hardware

to secure the VHX system to the dash.

4. Refer to the main manual for wiring instructions to complete the VHX installation.