To connect an AutoView Wireless transmitter
The following instructions will help you
connect your AutoView Wireless switch.
Should you require further assistance, please
consult your installer/user guide.
Power down the first computer that will be part of
your AutoView Wireless switching system and unplug
its peripherals. Place the transmitter near the
computer and connect the AutoView Wireless
transmitter cables into the computer’s PS/2
keyboard, PS/2 mouse and monitor connections.
Connecting the audio
Using the supplied audio cable, connect one end
to the transmitter’s audio input connection and the
other end to the computer’s audio output connection.
Connecting a local user to
the transmitter
Connect the local user’s keyboard, monitor and
mouse into the appropriately marked ports on the
rear of the transmitter.
Powering up the transmitter
and computer
Connect your transmitter to an AC power source with
one of the included power supplies and power up
your computer.
To
Contact Avocent Technical Support CALL (888) 793-8763 EMAIL [email protected] DOWNLOAD www.avocent.comAvocent, the Avocent logo, The Power of Being There and AutoView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. © 2004 Avocent Corporation. All rights reserved. 590-412-001A
Quick Installation Guide
AutoView
®
Wireless Switch
NOTE: Use only an Avocent-supplied power
supply. The transmitter must be powered up before
the computer.
(Continued on reverse side)
4
Installing the AutoView Wireless transmitter
(Repeat for each computer in system)
Connecting the computer’s peripherals
1
2
3
4
Transmitter
Connect the
transmitter
cables into the
appropriate
ports on the
computer.
Connect the audio.
Connect the local
user’s keyboard,
monitor and mouse.
Connect to an
AC power source.
