Installation Instructions for
Harrow Semi-Flush Mount
1.1
SF341-SF342
SF341, SF342
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
1
2
1A
3
To install the glass panels, remove the two top half rings by loosening the four cap nuts and then remove the four side brackets by
loosening the four screws on the bottom frame with a screwdriver.
Insert the glass panels into the fixture frame and reinstall the side brackets and fasten the screws on the bottom frame. Then reinstall
the two top half rings and secure them by fastening the four cap nuts.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Screw the threaded pipe to the bottom of the fixture.
Place the diffuser and washer (in that order) onto the threaded pipe and secure it in place with the hex nut (Do not over tighten).
Place the cup onto the threaded pipe and secure it in place by screwing the finial onto the threaded pipe.
1
4
5
Ceiling
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
DIFFUSER
FINIAL
4
2
SCREW
THUMB NUT
1
1
5
6
7
THREADED PIPE
HEX NUT
WASHER
CUP
LAMP
SCREWDRIVER
THUMB NUT
TOP HALF FRAME
SCREW
BRACKET
1
1
THUMB NUT
SCREW
BRACKET
GLASS PANEL
3
6
7
TOP HALF FRAME
FIXTURE FRAME
FIXTURE FRAME