SEAT
ASSEMBLY INSTRUCTION
E021C(3A)MOTION CHAIR
1PC
AA
BASE
1PC
BB
4PCS
CC
4PCS
DD
SCREW
M8x45MM
4PCS
EE
FLAT WASHER
M8x16. 5MM
LOCK WASHER
M8x8.5MM
2PCS
GG
ALU PLATE
This page lists all the contents included in the
box. Please take the time to identify the hardware
as well as the time to individual components to
this product. As you unpack and prepare for
assembly, place the contents on a carpeted or
padded area to protect them from damage.
2PCS
FF
NUT
1PC
HH
WRENCH
1
11
B
C
E
D
A
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
Clean surfaces with a dry or damp soft doth. Do not use abrasive cleaners. Hardware
may loosen over time. Periodically check that all connections are tight.
Remove all protective packing material and position base on floor.
Attach the seat(A) onto the base(B) with Alu plate(G) as the picture,
then using screws(C), flat washers(D), lock washers(E) and nuts(F).
Be sure to the arrows face to front. Tighten all the bolts and nuts.
Test the swivel rocker gently. If the rocker does not rock properly,
double check the assembly procedure especially.
F
H
A
B
2
/
