2. BRT Systems
  3. HVT-Junction
HVT-Junction

BRT Systems HVT-Junction User guide

  • Hello! I am an AI chatbot trained to assist you with the BRT Systems HVT-Junction User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
HVT-Junction
Quick Start Guide
HVT-Junction
Quick Start Guide
Please scan QR code A or visit
http://bit.ly/system-warranty
for warranty registration using
the UUID and Product Key.
View the full information on the LDSBus HVT-
Junction, application setup and installation at
http://bit.ly/ldsbus-resources
or scan QR Code B.
A
A
B
Note: Enable termination for last LDSBus Device in the bus
View the full information on the LDSBus HVT-
Junction, application setup and installation at
http://bit.ly/ldsbus-resources
or scan QR Code B.
Please scan QR code A or visit
http://bit.ly/system-warranty
for warranty registration using
the UUID and Product Key.
Setup Instructions:
The LDSBus HVT-Junction connects LDSBus Devices (Sensors / Actuators) to the LDSBus. Each junction can connect up to four LDSBus
Devices and additional LDSBus HVT-Junctions may be daisy chained to add more LDSBus Devices to the LDS Bus.
Step 1:
Connect the first LDSBus HVT-Junction to any
of the LDSBus Host Systems using an RJ45
(CAT5e) cable.
Step 2:
Connect the configured
LDSBus Device(s) to the LDSBus HVT-
Junction as shown
Step 3:
If there is more than one
LDSBus HVT-Junction in the system, chain
them together as shown.
Setup Instructions:
The LDSBus HVT-Junction connects LDSBus Devices (Sensors / Actuators) to the LDSBus. Each junction can connect up to four LDSBus
Devices and additional LDSBus HVT-Junctions may be daisy chained to add more LDSBus Devices to the LDS Bus.
Step 1:
Connect the first LDSBus HVT-Junction to any
of the LDSBusHost Systems using an RJ45
cable (CAT5e) cable.
Step 2:
Connect the configured
LDSBus Device(s) to the LDSBus HVT-
Junction as shown
Step 3:
If there is more than one
LDSBus HVT-Junction in the system, chain
them together as shown.
Sticker Area
B
Note: Enable termination for last LDSBus Device in the bus
Sticker Area
/