Hager Invicta 3 Operating instructions

Brand: Hager

Model: Invicta 3

Type: Operating instructions

Invicta 3

Instruction leaflet for fitting 250A Meter Pack

Fit the incoming device as normal, with the busbar

end of the connections loosely made.

Clip the pre-wired meter & fuse din-rail to the top

neutral mouldings in the lower position (A). Ensure

the cables to go behind the rail

Connect the loom leads to the incomer links at the

busbar stack (B) (L1, L2, L3 & N)

Ensure that all connections on incomer are tightened

to the recommended torque as listed in the incomer

instruction sheet. Ensure the connections on the

busbar links (B) are tightened to 7Nm

Fit the CT block to the pre-drilled holes (C)

Connect the earth lead to the earth stud

Fit the shroud supplied with the meter pack

A Meter Pack Instructions

(A)

(B)

(C)

(E)

(D)

(A)

(B)

(C)

Contents

Digital multi-function meter

3 pole CT block

3 x Fuses & carriers on din-rail

Wiring loom

Hager Ltd

Hortonwood 50

Telford

Shropshire

TF7 7FT

National Sales Hotline 0870 240 2400

National technical Support helpline 0870 607 6677

Incomer shroud

Instructions (including torque settings for electrical

connections)

Website: www.hagergroup.co.uk

Email us @: info@hager.co.uk

Shroud

CT block

Fuses

Din-rail

Meter

ZD0686

Hager Invicta 3 Operating instructions

Hager Invicta 3 Operating instructions

Hager Invicta 3 Operating instructions

Related papers

Other documents