2. Kampmann
  3. KaCool D, infra-red

Kampmann KaCool D, infra-red Installation Plan

  • Hello! I have reviewed the installation instructions for the KaCool D and KaCool D AF. This document outlines the cabling, setup, and operation of the infrared remote control system for these units. It covers both single-unit and group configurations, detailing electrical requirements and the fan controls. I am ready to answer your questions about the document.
  • What is the approximate range of the remote control?
    What is the maximum number of units that can be controlled in a group?
    What is the maximum fuse rating?
W1: Power supply
The number of connecting wires required including fuses is given on the individual control units.
Electrical supply: Note the technical connection conditions as stipulated by your energy supply company!
Cabling – Infra-red remote control actuation
Single unit, infra-red remote control
333
W1W1W1 LLLL
PEPEPEPE
NNNN
1111
2222
3333
VHVHVHVH VCVCVCVC
Range of
remote
operation
approximately
3 m
KaCool D AF
EC fan
230 V AC/50 Hz
Continuously
variable
230 V/
50 Hz
4-pipe: H 2-pipe: H/C
4-pipe: C
230 V/
50 Hz
Mains power
230 V AC/50 Hz
Fuse by others
max. 16 A
KaCool D
Group formation, infra-red remote control, max. 60 units
*) Lay shielded data cable, twisted pairs, e.g. UNITRONIC® BUS LD 1 x 2 x 0.22 mm² or similar, linear but
separate
from power lines!
W1: Power supply
W2: Bus signal RS485, max. cable length 700 m
W3:PlaceJP2“Endoftheline”for120Ohmterminalresistanceatthefirstandlastunit
W4: Insert on-site wire jumper
The number of connecting wires required including fuses is given on the individual control units.
Electrical supply: Observe the technical connection requirements laid down by utility companies!
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
3
W1
2*
W2
2*
W2
2*
W2
2*
W2
2*
W2
2*
W2
A
E
B
1
2
3
W4W4
A
E
B
1
2
3
W4
A
E
B
1
2
3A
E
B
1
2
3
L
PE
N
L
PE
N
1
2
3
1
2
3L
PE
N
1
2
3
VHVH VCVC
VH VC
L
PE
N
1
2
3
VH VC
L
PE
N
L
PE
N
1
2
3
1
2
3L
PE
N
1
2
3
A
E
B
1
2
3
VHVH VCVC
VH VC
L
PE
N
1
2
3
A
E
B
1
2
3
VH VC
L
PE
N
L
PE
N
1
2
3
1
2
3L
PE
N
1
2
3
VHVH VCVC
VH VC
L
PE
N
1
2
3
VH VC
KaCool D AF
EC fan
Unit 1
230 V AC/50 Hz
Continuously variable
KaCool D AF
EC fan
Unit 2
230 V AC/50 Hz
Continuously variable
KaCool D AF
EC fan
Unit 60
230 V AC/50 Hz
Continuously variable
Mains power
230 V AC/50 Hz
Fuse by others
max. 16 A
Range of
remote
operation
approximately
3 m
W3
Place
JP 2
W3
Place
JP 2
230 V/
50 Hz
230 V/
50 Hz
230 V/
50 Hz
4-pipe: H 4-pipe: H 4-pipe: H2-pipe: H/C
4-pipe: C
2-pipe: H/C
4-pipe: C
2-pipe: H/C
4-pipe: C
230 V/
50 Hz
230 V/
50 Hz
230 V/
50 Hz
KaCool D
/