User manual
WWW.LIVOO.FR
Reference : TEA271
Version : 1.4
Language : English
Vlogging video kit
User manual
1
Thank you to have purchased a product brand Livoo. We take great care in design, ergonomics and simple
use of our products. We hope that this product will give you complete satisfaction.
PLEASE READ ALL INSTRUCTIONS CAREFULLY
This instruction manual is also available on our website www.livoo.fr
SAFETY INSTRUCTIONS
The product is not suitable for children under 3 years of age due to the risk of choking.
Contains small parts, in order to prevent it from being swallowed, please ensure that any use by children is
carried out under adult supervision.
Do not expose the unit to abnormally high or low temperatures. Store the unit in a cool (room
temperature), dry and dust-free place and never expose the product to high temperatures or direct
sunlight. This product is not suitable for use underwater or in humid conditions. Make sure that your
vlogging kit always stays dry.
Do not attempt to replace or modify the leds in the led square.
Do not use a USB charger with excessive voltage to power the product. Ideally use a device with a
maximum of 2.1 amps.
Be sure to unplug the USB cable when not in use.
If you think this product is damaged in any way, please do not use it.
To avoid the risk of electric shock, do not insert the power cord with wet hands.
Please dispose of waste and residues at the end of the product's life in accordance with local laws and
regulations.
In the unlikely event of overheating, smoke, or unpleasant odors from the unit, unplug it immediately from
the charging cable.
Protect the product from falls, shocks, and impacts.
FEATURES
Vlogging video kit
Tripod
Rechargeable LED flash
3 lighting modes, warm, soft and white (3500-7200K)
10 adjustable light brightness, 96 LEDs
Phone holder for phones from 6.5 to 10 cm wide
Wired microphone
Bluetooth® compatible remote control photo/video shutter release
USB charging cable included
User manual
2
PRODUCT DESCRIPTION
1. LED Ring Board
2. Tripod Head
3. LED Ring Board Holder
4. Phone Holder
5. Microphone + 3.5mm cable
6. Tripod Base Stand
360° Rotation to adjust
the tightness
360° Rotation to
adjust the tightness
Press this button to adjust
Tripod Head angle
360°
User manual
3
SET UP
Screw Tripod Head in to LED
Ring Board
Put in to Square Slot and
then scre it tightly
Screw LED Board
Holder in to Tripod
Base stand
Square slot
From the outmost round
hole to put in and then
screw in
Adjustable lengh
Round Hole
User manual
4
Follow five steps then finished installation
Put in to Square Slot and
then screw it tightly
Square slot
After step, Screw in Phone Holder to make LED Ring Board
holder steady
User manual
5
a. Using LED Light
1. Turn on the LED / Change the lighting mode
Briefly press the button to turn on the LED, the white LED lights up. Each press of the button will
change the lighting mode (warm, soft and white).
2. Adjust the brightness
Briefly press the "light intensity -" button, the brightness will decrease.
Briefly press the button " light intensity + " the brightness increases.
When the brightness is maximum, the light will flash three times.
3. Charging the LED lamp
Connect the Micro USB charging cable, when the red light is on, the lamp is charging, when the
green light is on, the lamp to be finished charging.
Brightness -
Fully charged indicator
light (Green)
Brightness +
Power switch /
Color temperature mode
Charging indicator
light (Red)
General purpose ¼ nut
Micro Charging Port
User manual
6
b. Using microphone
c. Product bracket installation
Correctly installed microphone : the
microphone body clips perfectly onto the
microphone stand
Incorrect installation: When you insert the
microphone body there is a gap between
the body and the microphone stand.
Microphone body
Microphone audio output
Fixed soft plastic head
(to avoid scratching the cell phone)
3.50 mm headset plugged into the
phone (audio output)
Microphone stand
Stand for attaching the microphone to the phone
stand
Microphone
Microphone
protection foam
User manual
7
d. Using Bluetooth® remote control
When using for the first time: remove the protective film from the batteries.
e. Bluetooth® pairing
If the unit has never been paired with a Bluetooth® device before, you need to follow the instructions
below to pair the remote control with your Bluetooth® device:
1. Turn on the switch, the blue light flashes, then the remote control is ready to be paired.
2. Activate the Bluetooth®on your cellphone and search for pairing name AB Shutter3.
3. Click AB Shutter3 to connect, if the indicator goes off, it means that the remote control has
connected successfully.
4. When turning on the remote control can automatically connect to the last device that you had
paired.
Take photo by press the button
0n/off switch
User manual
8
EU DECLARATION OF CONFORMITY
We
DELTA
BP61071
67452 Mundolsheim – France
Herewith declare under our sole responsibility, that the radio equipment
Vlogging video kit
TEA271 (Frequency range 2402 – 2480MHz)
Fulfils the essential requirements of the Directive 2014/53/UE
The following standards were applied:
Radio:
ETSI EN 300 328 V2.2.2 (2019-07)
EMC:
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-17 V3.2.4 (2020-09)
Health and Safety:
EN 62368-1 : 2014 + A11 : 2017
EN 62479 : 2010
EN 50663 : 2017
Mundolsheim, 24/03/2021
User manual
9
Correct disposal of the unit
(Electrical and Electronic Equipment)
(Applicable in the European Union and the rest of Europe that have adopted separate collection systems countries)
The European Directive 2012/19/UE on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical
appliances must not be disposed of in the normal household waste stream. Old appliances must be collected separately in order
to optimize the recovery and recycling of the materials they contain and reduce the impact on human health and the
environment. The symbol of the crossed out dustbin is marked on all products to remind the obligations of separate collection.
Consumers should contact their local authority or retailer for information concerning the correct disposal of their product.
Non contractual illustration
Product information is subject to change without prior notice.
LIVOO
BP 61071
67452 Mundolsheim
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Livoo TEC582 User manual
-
-
Livoo TEA289 Lighted Induction Charger User manual
-
-
-
-
-
-
Livoo LH103 User manual
-
