Instruction Manual
3
OPERATIONS
Charging the speaker
Before first using, fully charge the battery by using the supplied USB cable. Plug in to any USB port supplying
power (Laptop, Computer, AC Charger, Car Charger, etc.).
When the LED indicator is RED, the speaker is charging, the LED indicator goes off when the device is fully
charged.
Power on/off
Press and hold down the power button to switch the appliance on/off. A voice tells you when the
appliance is switched on or off.
Bluetooth® Pairing
When the Speaker turned on, the voice prompts “The Bluetooth® device is ready to pair”.
Open the Bluetooth® settings of your phone, tablet or other Bluetooth® enabled audio device and select
“TES237”.
After the pairing is successful, the voice prompt “The Bluetooth® device is connected successfully”.
Speaker will automatically be paired if the mobile device has been paired before.
Turn off Bluetooth® on your phone, tablet or other Bluetooth® enabled audio device to stop pairing, the
voice message "The Bluetooth® device is ready to pair" will be sent.
Playing Music
Select a song, artist, genre, or playlist on your phone, tablet or other Bluetooth® enabled audio device.
Press to start or pause the music.
Press and hold the + or - button to adjust the volume.
Short press the + or - button to go to next or last songs.
Induction charging function
Make sure your phone is compatible for wireless charging.
First plug the wireless charger using the included micro USB cable into the USB port of your wall adapter.
Please note charging speeds depends on the input power into the wireless charger
Place your mobile phone on the charging pad. You can check the charging status on the screen of your phone.
Remark: If your mobile phone supports 10W wireless charger, the speaker will Auto charge base on 10W. If
your mobile phone supports only 5W wireless charger, the speaker will Auto charge base on 5W.
Aux Function
Play music directly: use a 3.5mm Aux-in cable to connect your device through the AUX in port.