Polaris Vac-Sweep 360 Operating instructions

Brand: Polaris

Model: Vac-Sweep 360

Type: Operating instructions

1. Remove the back-up valve from the feed

hose. Please note: The replacement parts

included are designed to work with the

#9-100-1200 back-up valve only.

2. Unscrew and remove the back-up valve col-

lar.

3. Pull apart the back-up valve case.

4. Remove the mechanism from the front casing.

5. For Mechanism Replacement — Push the

new mechanism into the front casing. Make

sure the back-up jet is in the jet opening at

the bottom of the case.

For Case Kit Replacement — Push the

mechanism into the new front casing. Make

sure the back-up valve jet is in the jet open-

ing at the bottom of the case.

6. Align the key on the rear casing with the slot

on the front casing. Push the front and the

rear casings together.

7. Screw on the back-up valve collar until it

locks into place. Do not overtighten.

8. Push the hose nuts onto the ends of the

back-up valve. Position the back-up valve so

the flow arrow is pointing toward the Polaris.

9. Push one end of the hose onto the back-up

valve and twist the hose nut onto the hose.

Tighten the hose nut by twisting counter-

clockwise; do not overtighten. Repeat with

the other end of the hose.

10. Push the float next to the back-up valve as

close to the valve as possible.

Polaris 360 In-line Back-up Valve

Mechanism or Case Kit

Replacement Instructions

Collar Key

Mechanism

Rear

Casing

Front

Casing

Back-up

Jet

Opening

Slot

1’ Hose

Section

Polaris

Float

Flow ArrowHose Nut

and the Polaris 3-wheeled

cleaner design are registered trademarks of Zodiac Pool Systems, Inc.

All other trademarks referenced herein are the property of their respective owners.

TL-801 Rev B

Zodiac Pool Systems, Inc.

2620 Commerce Way, Vista, CA 92081

1.800.822.7933 | www.polarispool.com

Polaris Vac-Sweep 360 Operating instructions

Polaris Vac-Sweep 360 Operating instructions

Polaris Vac-Sweep 360 Operating instructions

Related papers

Other documents