FMUser GP100 User manual

Type
User manual
1 / 4
USER MANUAL FOR FMUER GP100 ANTENNA
Step1: Check the package.
After you have received the antenna package, check and make sure the following items are included:
Step2: Choose the frequency:
There are five antenna elements with center frequencies labeled on them. Each element is applicable for frequency of
+/-2.5mhz from the center frequency.
For example, the antenna element labeled with 98mhz is applicable for 95.5-100.5mhz, the one labeled with 103mhz is
applicable for 100.5-105.5mhz, etc.
If the transmitter will be using 97mhz, you should choose the element labeled with 98mhz:
Step3: Connect the frequency element(pick one from B1-B5) to the main rod(C), check the picture below:
2 / 4
Step4: Unscrew the grounding base(F) and put the cable through inside, screw the base tight after cable connected.
3 / 4
Step5: Connect the grounding base(F) to the main rod (C), then connect grounding elements (D) to the base (F).
So far, the antenna assembly is completed. Well done!
4 / 4
Step 6: After antenna is assembled, use the fixtures (E) to fix the assembled antenna to the pole/tower/mast:
Attention:
1. The antenna should be fixed with a pole and installed at least 2 meter away from ground.
2. The antenna should be away from walls and other obstructions.
If you have any questions or need any technical support, please contact us by email at rita@fmuser.net, we
will reply in 24 working hours.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

FMUser GP100 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI