CAUTION: Use gas purge switch on wire feeder or
power source to check gas flow or shut off
wire feed before triggering the torch to avoid
damaging the gas meter.
1. Place conical end of gas meter over end of mig torch
nozzle or tig torch gas shielding cup.
2. Position torch so that the gas
meter is in the vertical pos-
ition.
3.
With the argon or argon
mixed gas flowing, read
the meter at the center
of the ball.
INSTRUCTIONS for
F-14-328
February, 1996
CAUTION: Use gas purge switch on wire feeder or
power source to check gas flow or shut off
wire feed before triggering the torch to avoid
damaging the gas meter.
1. Place conical end of gas meter over end of mig torch
nozzle or tig torch gas shielding cup.
2. Position torch so that the gas
meter is in the vertical pos-
ition.
3.
With the argon or argon
mixed gas flowing, read
the meter at the center
of the ball.
INSTRUCTIONS for
F-14-328
February, 1996
®
®
ESAB
ESAB Welding & Cutting Products
PO Box 100545, Florence SC 29501-0545
F-14-328 2/96 1M Printed in U.S.A.
ESAB
ESAB Welding & Cutting Products
PO Box 100545, Florence SC 29501-0545
F-14-328 2/96 1M Printed in U.S.A.
Gas Meter, P/N 19043
Gas Meter, P/N 19043
INSTRUCTIONS for
F-14-328
February, 1996
CAUTION: Use gas purge switch on wire feeder or
power source to check gas flow or shut off
wire feed before triggering the torch to avoid
damaging the gas meter.
1. Place conical end of gas meter over end of mig torch
nozzle or tig torch gas shielding cup.
2. Position torch so that the gas
meter is in the vertical pos-
ition.
3.
With the argon or argon
mixed gas flowing, read
the meter at the center
of the ball.
®
ESAB
ESAB Welding & Cutting Products
PO Box 100545, Florence SC 29501-0545
F-14-328 2/96 1M Printed in U.S.A.
Gas Meter, P/N 19043
INSTRUCTIONS for
F-14-328
February, 1996
CAUTION: Use gas purge switch on wire feeder or
power source to check gas flow or shut off
wire feed before triggering the torch to avoid
damaging the gas meter.
1. Place conical end of gas meter over end of mig torch
nozzle or tig torch gas shielding cup.
2. Position torch so that the gas
meter is in the vertical pos-
ition.
3.
With the argon or argon
mixed gas flowing, read
the meter at the center
of the ball.
®
ESAB
ESAB Welding & Cutting Products
PO Box 100545, Florence SC 29501-0545
F-14-328 2/96 1M Printed in U.S.A.
Gas Meter, P/N 19043
-
1
ESAB OXWELD® Gas Meter Troubleshooting instruction
- Type
- Troubleshooting instruction
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
ESAB MultiMaster 160 Mig / Tig / Stick Welding Package User manual
-
-
-
-
-
-
-
-
-