2. FSR
  3. SYM-PD30AB-1CC

FSR SYM-PD30AB-1CC, SYM-PD-1CC Charger, SYM-PD24AB-1CC, SYM-PD24AW-1CC, SYM-PD30AW-1CC Installation guide

  • Hello! I have reviewed the installation instructions for the FSR SYM-PD24 and SYM-PD30 models. This document provides detailed steps on how to install keystone connectors, make wiring connections, and install/remove the inserts. It also highlights the restrictions on types of inserts and the prohibition of AC power wiring. I'm ready to answer your questions about the installation process or any other details in the document.
  • What type of inserts can be installed?
    Can AC power wiring be installed?
    How can insert be installed?
    How can insert be removed?
INSERT INSTALLATION AND REMOVAL
FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43421 LIT1819
SYM-PD24 / SYM-PD30 Installation Instructions
SELECT LOCATION FOR ASSEMBLY. IF APPLICABLE, INSTALL KEYSTONE CONNECTORS
(SOLD SEPARATELY) INTO INSERTS (SINGLE OR DUAL). MAKE WIRING CONNECTIONS
AS REQUIRED AND INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS
ARE TO BE INSTALLED AT A LATER DATE, INSTALL BLANK INSERTS. FRONT FACE MUST
BE CLOSED WITH KEYSTONE OR BLANK INSERTS.
SYM-PD24 SHOWN
a. TO INSTALL, PUSH INSERT WHERE
INDICATED, SNAPPING INSERT INTO
ASSEMBLY.
b. TO REMOVE, INSERT SCREWDRIVER
WHERE INDICATED, PRYING INSERT
OUT OF ASSEMBLY.
INSERT
SCREWDRIVER
HERE
INSERT
SCREWDRIVER
HERE
PUSH HERE
PUSH HERE
UNDERSIDE VIEW
OPENING
FOR WIRES
TIE WRAP POINTS
INSTALLATION OF SNAP-IN MODULES IS RESTRICTED TO LOW
VOLTAGE DATA AND SIGNAL TYPE INSERTS. ADDITION OF ANY AC
POWER WIRING IS NOT PERMITTED.
NOTE:
/