2. FSR
  3. SYM-DIN-2AC-1SS-AW

FSR SYM-DIN-2AC-1SS-AW Installation guide

  • Hello! I have reviewed the FSR SYM-IN installation instructions. This document outlines the steps for installing various frame sizes of the SYM-IN table assembly, including how to install and remove the assembly and its inserts. I can help you with the installation process and answer your questions about the features.
  • How do I install the assembly?
    How do I remove the assembly?
    How do I install inserts?
    How do I remove inserts?
FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43346 LIT1728A
TYPE FLANGE SIZE
A FRAME
B FRAME
C FRAME
D FRAME
6.30"
7.73"
8.69"
10.12"
CUT OUT SIZE
`
1/16
6-1/16"
7-7/16"
8-7/16"
9-7/8"
SYM-IN Installation Instructions
1. SELECT LOCATION FOR ASSEMBLY AND CUT APPLICABLE HOLE
IN TABLE. INSERT ASSEMBLY INTO HOLE AND PUSH DOWN ON
FLANGES. TO REMOVE ASSEMBLY FROM TABLE, PRY BOTTOM
OF CAPTURE SPRING OFF ASSEMBLY FRAME.
ASSEMBLY
CAPTURE SPRING
TO REMOVE ASSEMBLY, INSERT
SCREWDRIVER THRU OPENING AND
PRY BOTTOM OF CAPTURE SPRING
OUT OF ASSEMBLY FRAME LIP, BOTH
SIDES. LIFT ASSEMBLY OUT OF HOLE
TO COMPLETE REMOVAL.
SHARP TO 1/8" MAX
RADIUS CORNERS
5.00"
`
1/16
CUT OUT
SIZE
FLANGE
SIZE
TABLE
HOLE CUT OUT
2.
INSERT INSTALLATION AND REMOVAL
a. TO INSTALL, PUSH INSERT WHERE INDICATED,
SNAPPING INSERT INTO ASSEMBLY.
b. TO REMOVE, INSERT SCREWDRIVER WHERE
INDICATED, PRYING INSERT OUT OF ASSEMBLY.
PUSH HERE
PUSH HERE
INSERT SCREWDRIVER HERE
INSERT SCREWDRIVER HERE
IF APPLICABLE, INSTALL KEYSTONE CONNECTORS (SOLD SEPARATELY) INTO
INSERTS (SINGLE OR DUAL), MAKE WIRING CONNECTIONS AS REQUIRED, AND
INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS ARE TO BE
INSTALLED AT A LATER DATE INSTALL BLANK INSERTS. FRONT FACE MUST BE
CLOSED WITH KEYSTONE OR BLANK INSERTS.
/