FSR SYM-PD24AB-1CC Installation guide

INSERT INSTALLATION AND REMOVAL

FSR

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207

43421 LIT1819

SYM-PD24 / SYM-PD30 Installation Instructions

SELECT LOCATION FOR ASSEMBLY. IF APPLICABLE, INSTALL KEYSTONE CONNECTORS

(SOLD SEPARATELY) INTO INSERTS (SINGLE OR DUAL). MAKE WIRING CONNECTIONS

AS REQUIRED AND INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS

ARE TO BE INSTALLED AT A LATER DATE, INSTALL BLANK INSERTS. FRONT FACE MUST

BE CLOSED WITH KEYSTONE OR BLANK INSERTS.

SYM-PD24 SHOWN

a. TO INSTALL, PUSH INSERT WHERE

INDICATED, SNAPPING INSERT INTO

ASSEMBLY.

b. TO REMOVE, INSERT SCREWDRIVER

WHERE INDICATED, PRYING INSERT

OUT OF ASSEMBLY.

INSERT

SCREWDRIVER

HERE

INSERT

SCREWDRIVER

HERE

PUSH HERE

UNDERSIDE VIEW

OPENING

FOR WIRES

TIE WRAP POINTS

INSTALLATION OF SNAP-IN MODULES IS RESTRICTED TO LOW

VOLTAGE DATA AND SIGNAL TYPE INSERTS. ADDITION OF ANY AC

POWER WIRING IS NOT PERMITTED.

NOTE:

This manual is also suitable for

Download PDF