Page is loading ...
Use Manual
1. Press the switch 1 of remote controller, the first channel of the circuit board
starts output, and the indicator 1 on the remote controller lights up. Press the
switch 1 of remote controller again to turn off the output of the first channel ,
and turn off the indicator 1 on the remote controller .
2. Switch 2 to 12 on the remote controller are the same as switch 1, which can
controller the output channel 2 to 12 of the corresponding channel.
3. Switch 13 on the remote controller is the function key. Press once to close all
open channels, and store the status of each channel in memory. Press again to
restore the last memory state. Long press to restore factory Settings.
4. Switch 14 on the remote controller is the function key. Press it to turn off the
backlight on the remote controller and turn on the standby indicator. Press any
key to restore the backlight. Double-click to enter the output mode setting of
each channel, and then press the corresponding channel switch as required to
select the working mode of the channel. After the setting is completed, press
switch 14 to save, otherwise give up this setting. Press the combination key
switch 14+ any key to enter the backlight color setting mode, and then press
switch 1 or switch 4 to change the color. After the setting is complete, press
switch 14 to save and exit, otherwise do not save and exit.
5. After the circuit board is connected to the main power supply, ACC (red)
control line should be connected again. The switch module starts to stand by,
and the channel of the circuit board is controlled by the remote controller.
6. Each channel of the circuit board has the corresponding maximum working
current fuse, do not overload with the load, otherwise there will be a failure.
Warning 66tatement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
/