LACT-10
HEAVY DUTY TRUNK LIFT KIT
Thank you for purchasing the Dakota Digital trunk lift kit. LADT-6/8/10 units provides 110
pounds of lifting force and 10 inches of travel respectively to open even the heaviest trunk lids.
WARNING: Due to the tremendous power of this unit, failure to mount the unit according
to the following instructions can result in damage to your vehicle.
This unit uses a screw drive actuator with built in limit switches. Figure 1 shows the
dimensions of the actuator.
The actuator should be mounted as shown in figure 2. With the trunk closed, the
actuator should be in its fully retracted position. When the trunk is open, the actuator should be
in its fully extended position. Failure to follow these guidelines could result in the actuator caving
in the trunk or breaking the hinges. Figure 3 shows the included mounting brackets.
Wiring for the LACT-10 is as follows:
RED - +12 volts fused at 10 Amps.
BLACK - GROUND
YELLOW - to trunk motor
ORANGE - to trunk motor
The switch connections are as follows, looking at the back of the switch.
ORANGE
BLACK
RED
BLACK
YELLOW
Figure 1.
-
1
-
2
Dakota Digital LACT-6 Technical Manual
- Category
- Motorcycle Accessories
- Type
- Technical Manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Dakota Digital PAC-3200 Technical Manual
-
-
-
-
-
-
-
-
-
Other documents
-
Directed Electronics Automate 552 User manual
-
Viper Responder LE 5701 Installation guide
-
Avital 3200 Installation guide
-
AutoCommand 20024 Installation guide
-
-
-
Directed DS4+ Installation guide
-
Keystone Electric Actuators model EPI-2 OM11 DeviceNet interface IOM Owner's manual
-
Emerson FIELDVUEDVC6200 Quick start guide
-
Invacare USER GUIDE User manual
