Standard Horizon HX600S HX600S-LI MMSI Owner's manual

Standard Horizon Marine Division of Vertex Standard

10900 Walker Street, Cypress, CA 90630 714/827-7600 800/767-2450

www.standardhorizon.com, marinetech@vxstdusa.com

Storing a MMSI number into a HX600S or HX600S-LI

1. Turn the radio off.

2. Press and hold down the SQL button and then press and hold the red

power key until the display shows "MMSI REG"

3. Press the channel up key one time. The display will show six numerical

digits across the top of the display.

4. Press the channel up or down key until the first digit on the display

corresponds with the first digit of your MMSI number. Then press the

"MEM" button.

Note:

Notice the numeral on the bottom left side of the screen. These represent

which digit you are currently setting in the 9 digit MMSI number (1 for the first

digit and 9 for the last digit).

5. Press the channel up or down key to select the second digit to correspond

with your MMSI number. Then press the "MEM" button.

6. Repeat step 5 until the ninth digit is set.

7. After pressing the MEM key in step 6 the first digit in the MMSI number will

be blinking, press the SQL button one time to store the MMSI number.

8. Turn the radio off and back on again using the red power key.

9. At this point, the MMSI number is stored in the radios memory.