Netgear ReadyNAS 600B User manual

Netgear
Brand
Netgear
Model
ReadyNAS 600B
Type
User manual

This manual is also suitable for

Disk Installation Guide
Important instruction on how to install hard disks in your ReadyNAS
READYNAS
600 version B
the components
side
the connector end
☼
☼
Prepare for Installation
2Install the hard disk mounting brackets
1 Remove the top cover to access disk cage
ReadyNAS 600 case (version B)
Remove the 3 screws in back.
Remove top cover
Disk installation Accessories
Install the bracket
to the new hard disk
Prepare SATA hard disk drives
the Components Side
F
4 x
16 x
F
Read this Guide before you install the disks.
Prepare the follows for the disk installation:
ReadyNAS 600 disk-less system
Disk drive brackets and screw in accessory box
Ethernet cable and power cable
Hard disk drives (not included)
Screw driver (not included)
4Re-install top cover and front panel
Refer to the Getting Started Guide for further instruction.
3Install the hard disks into cage
Infrant Technologies Inc.
3065 Skyway Ct., Fremont CA 94539
Phone: (510)4 38-7982
Email: [email protected]
Web: www.infrant.com
© 2005 Infrant Technologies, Inc. All rights reserved.
ReadyNAS, RAIDar, RAIDiator, X-RAID and FrontView are trademarks
of Infrant Technologies, Inc. All other product names are the properties
of their respective owner.
Printed in U.S.A. P/N: IT-05-1-1066-U-01 10/2005
Hard disks with
mounting bracket installed System case with
easy access disk cage
1) Install the disks into the cage. 2) Push the drives into SATA connector completely,
and secure the drives with screws.
Re-install top cover and screw on in the back. Done with disk installation.
4
3
2
1
☼
4
3
2
1
  • Page 1 1
  • Page 2 2

Netgear ReadyNAS 600B User manual

Netgear
Brand
Netgear
Model
ReadyNAS 600B
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents