www.inateck.com
Instruction Manual
BTSP-20
Bluetooth Speaker
BTSP-20 Bluetooth Speaker
Instruction Manual (EN)
I. Packing list
● BTSP-20*1
● Micro USB Charging Cable*1
● AUX Cable*1
● Users manual*1
● Suction cup*1
II. BTSP-20 Diagram
Power Switch
- Turns the speaker on and off
Hand-free
- Answers and ends calls
Volume down
Volume up
3.5mm audio input
- Connect a 3.5mm audio cable from this port to another device to play audio
from that device
5V Micro USB Power Port
- Used to recharge the speaker’s battery
LED indicator
III. Specs
IV. Powering on/off
There is a power switch located on the side(#1 on the diagram) of
the speaker. Push the switch to turn it on & off.
V. Connecting the speaker
Wireless/Bluetooth
This speaker can connect wirelessly to devices that have Bluetooth.
Use the following steps:
1. Press the power switch for 6 seconds
2. The light on the front will be flashing white and red light
alternately, indicating that the speaker is in pairing mode
3. Go to your device’s Bluetooth connection screen and choose
“Inateck BTSP-20”
4. If you are asked for a password,type 0000
5. The blue light will stop flashing and your speaker will be
connected
6. When the speaker is paired and connected with PC, please
select it as the default playback device in the Windows Sound
settings.
*The method of connecting Bluetooth may vary with your device.
Please refer to your device’s manual or manufacturer if the above
steps do not work.
Wired
There is a 3.5mm port on the side (#5 on the diagram) of the
speaker which can be used to connect to another device by using
the included 3.5mm cable. If your device uses a port other than
3.5mm, then you will need an adaper cable.
Product Name
Product Model
Product Size
Charging Interface
Water-proof
AUX 3.5mm line input impedance
Input Sensitivity
Output Power
Battery built-in
System Support
Bluetooth Speaker
Inateck BTSP-20
85mm*85mm*45.5mm
Micro USB
IPX5 standard water-resistant
47kΩ
560MV
3W
3.7V 800mAh rechargeable battery built-in
WindowsXP/Vista/7/8; Mac; ios; Android
VI. Features
Volume control
The buttons on this speaker can control the volume. Control volume
via the paired devices, such as iPhone, iPad, Mobile phones,
PC/Mac…etc.
Volume up
Volume down
Speakerphone/Hands Free calling
This speaker can function as a speakerphone for your mobile phone
(Only while connected in Bluetooth mode).
- Short press “Hand-free” to answer phone call.
- Short press again to end a call.
Water-Resistant
This speaker is compliant with IPX5 waterproof standard “splash
proof in all directions”. Neither put BTSP-20 under jet-water nor sink
into water.
VII. Battery
Charging
Connect the 5V micro USB power port on the speaker to the USB
port of a power source such as a laptop or a USB wall adapter. A
micro USB cable is included for this use.
There is a light on top of the power switch that will indicate the
following charging statuses:
- Charging: Red LED turns ON
- Fully charged: LED turns OFF
- Low power (<21%): Red LED twinkles
Mirco USB Cable
USB port on a
PC/ laptop
USB wall adapter
VIII. Warning/Caution
Btspeaker should be charged with phone USB chargers and
computer USB port only! Chargers for other devices such as tablets
should not be used. USB chargers that provide more than 1A while
chargers (ipad charger etc.) could severely damage Btspeaker’s
battery and potentially cause malfunctions.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Website: Hp://www.inateck.com
Email: [email protected]
(Service me: Mon - Fri 9:00AM - 5:00PM CET)
Tel: 0341-5199 8407
/
