PARTS & COMPONENTS ASSEMBLY
Weighing Platform
Scale
Cross Bowl Holder
Adjustment Knob
Bowl
1. Place the scale on a flat and
solid surface.
2. Cut the ties under the weighing
platform to remove the protective
cardboard.
3. Unscrew the screws located at the
outermost holes on the weighing
platform of the scale.
Set screws and nuts aside.
4. Place the cross bowl holder
on the scale.
Insert the screws and tighten them
with the nuts.
Note: It is very important to align
the holes of the cross bowl holder
with those on the weighing platform
of the balance.
5. Place the bowl on the cross
bowl holder.
Calibrate the scale by turning
the adjustment knob on top
of the scale until the needle
indicates "5 kg / 0 lb".
PRINTED IN CHINA FOR : ATLANTIC PROMOTIONS INC. LONGUEUIL (QUÉBEC) J4G 1V6
CUSTOMER SERVICE: STARFRIT.COM/EN/CONTACT-US
ADVISE FOR USE & CARE
1. Always use the scale on a hard flat surface.
2. Clean the scale with a slightly damp cloth.
3. Avoid contact with water. DO NOT immerse the scale in water.
4. All plastic parts should be cleaned immediately after contact with fat,
spices, vinegar and strongly flavored/colored food. Avoid contact with
acid citrus juices.
5. DO NOT use chemical or abrasive cleaning agents.
6. Not for commercial use.
SUBSCRIBE TO THE NEWSLETTER TO LEARN MORE ABOUT OUR PROMOTIONS!
.COM
INSTRUCTIONS FOR USE
RETRO KITCHEN SCALE
