1. Attach the vent clamp to a vent in your vehicle.
Note: Ensure the position of the phone will not obstruct your view of the road.
2. Rotate the knob to secure it in place
3. Attach the nut to the vent clamp (refer to image 3 below for correct orientation).
4. Attach the clamp to the rear of the charger.
5. Rotate the tightening knob to secure in place. Connect the charger to a 12V socket
in your vehicle using the supplied USB cable.
6. Place your mobile phone into the cradle, the arm clamps on both sides will
automatically close.
7. To remove your phone, press the button gently, the arm clamps will open
automatically.