2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Digi
  6. LCD Application Kit 7''

Digi LCD Application Kit 7'' Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Digi LCD Application Kit 7'' Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
7” WVGA LCD Application Kit
1
Quick Start Guide
Verify Kit Contents
This Quick Start Guide
7” LCD Display with Touch Screen
(assembled on its circuitry board)
Quick Start Guide
7” WVGA LCD
Application Kit
2
Hardware Connection
a
Connect the 80-pin at cable to connector LCD1 on the development
board.
Note: If necessary, please refer to the Hardware Reference Manual for
additional information about switch/jumper settings on your development
board.
ConnectCore Wi-i.MX51
ConnectCore Wi-i.MX53
ConnectCard for i.MX28
™
Stylus for
Touch Screen
© Digi International, Inc., 2013
Digi, Digi International, the Digi Logo, Digi JumpStart Kit, and ConnectCore are trademarks or registered trademarks of Digi International, Inc., in the United States and other countries worldwide. All other trademarks are property of their respective owners.
a
To obtain a materials list and installation instructions specic to your
platform, go to http://www.digi.com/support/.
3 Download Documentation
b
From the “Select a Product” drop-down box, select “Application Kits”.
™
2.1
ConnectCore for i.MX51 Development Kit
Refer to the provided documentation for hardware and/or operating
system specic information.
a
4 What’s Next?
2.3
ConnectCard for i.MX28 Development Kit
a
Connect the 80-pin at cable to connector PARALLEL LCD (P1)
on the development board.
2.2
a
ConnectCore for i.MX53 Development Kit
a
Connect the 80-pin at cable to connector LCD (P4) on the development
board.
a
b
b
Connect the 40-pin FFC cable to connector J12 on the development board
90001127-88
F
/