Installation information
16
Climate class
The appliance is designed for use within
a certain climate range (ambient tem-
peratures) and should not be used out-
side this range. The climate range of the
appliance is stated on the data plate in-
side the appliance.
Climate
class
Room temperature
SN 50°F to 90°F / 10°C to 32°C
N 60°F to 90°F / 16°C to 32°C
ST 60°F to 100°F / 16°C to
38°C
T 60°F to 109°F / 16°C to
43°C
Operating in a room which is too cold
will cause the compressor to turn off for
too long, causing the internal tempera-
ture in the appliance to rise, resulting in
damage.
Risk of damage.
In environments with high humid-
ity, condensation may appear on the
external surfaces of the appliance.
This condensate can cause corrosion
on external appliance panels.
To prevent this, it is advisable to in-
stall the appliance in a dry and/or air-
conditioned room with sufficient ven-
tilation.
After installation, make sure that the
appliance door closes properly, that
the specified ventilation gaps are ad-
hered to, and that the appliance is in-
stalled in accordance with these in-
stallation instructions.
Installation notes
Load-bearing capacity of the niche
floor
The floor of the space where the appli-
ance is to be installed must be flat and
level.
It must be made from strong, rigid ma-
terial.
The appliance is extremely heavy when
fully loaded, and the floor it stands on
must be able to bear its weight. If nec-
essary, seek the advice of an architect
or structural engineer.
When fully loaded, the weight of the ap-
pliance is about:
F 2411 Vi 575 lbs
(261 kg)
F 2801 Vi, F 2811 Vi 811 lbs
(368 kg)
F 2901 Vi, F 2911 Vi 939 lbs
(426 kg)
Door hinging
The appliance is supplied with a
fixed hinge. If you need to change
the door hinging to the other side,
please contact the Miele Technical
Service.
On no account should you attempt
to change the door hinging yourself.
Adjoining cabinetry/units
The appliance is screwed to the adjoin-
ing cabinetry/units to the side and
above. For this reason, it is essential
that all cabinets/units are fixed to the
ground and/or wall.