2. Metrologic
  3. Voyager RF series

Metrologic Voyager RF series, MS9530 Voyager RF Series Quick Configuration Manual

  • Hello! I am an AI chatbot trained to assist you with the Metrologic Voyager RF series Quick Configuration Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
MS9530 Voyager RF Quick Configuration guide 1 Printed: December 2002
Version: 1.0 Status: Approved
MS9530 Voyager RF Quick Configuration guide 2 Printed: December 2002
Version: 1.0 Status: Approved
QUICK CONFIGURATION GUIDE
1.- Link MS9530 Voyager RF with Base Station.
-Please read the following barcodes in the required order to fix Voyager RF interface and
complete linking:
1º.-
Enter configuration
2º.- (*) Skip this step if you just want to change the link to another
Base station.
Following parameters are set:
-Base Station serial number :9999999999
-Voyager ID: 1
3º.-
Ready to read the new Serial number of Base Station to
send data to.
4º.-
Read Base Station
serial number.
5º.-
Exit Configuration
(Unit should re-start and link with Base Station)
MS9530 Voyager RF Quick Configuration guide 3 Printed: December 2002
Version: 1.0 Status: Approved
2.- MS9530 Voyager RF ID:
- Up to five units can work together with same Base Station. It is requested that each of them
uses a different ID. Use this section to fix the desired Identifier into Voyager RF.
3.- WEDGE BASE STATION Minimum configuration: PC connection
-Please read the following barcodes in the required order:
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-
MS9530 Voyager RF Quick Configuration guide 4 Printed: December 2002
Version: 1.0 Status: Approved
3.- RS-232 BASE STATION Minimum configuration ( 9600,8,N,1, CRLF)
-Please read the following barcodes in the required order :
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-
/