Metrologic MS9530 Voyager RF Series Quick Configuration Manual

Type
Quick Configuration Manual

This manual is also suitable for

MS9530 Voyager RF Quick Configuration guide 1 Printed: December 2002
Version: 1.0 Status: Approved
MS9530 Voyager RF Quick Configuration guide 2 Printed: December 2002
Version: 1.0 Status: Approved
QUICK CONFIGURATION GUIDE
1.- Link MS9530 Voyager RF with Base Station.
-Please read the following barcodes in the required order to fix Voyager RF interface and
complete linking:
1º.-
Enter configuration
2º.- (*) Skip this step if you just want to change the link to another
Base station.
Following parameters are set:
-Base Station serial number :9999999999
-Voyager ID: 1
3º.-
Ready to read the new Serial number of Base Station to
send data to.
4º.-
Read Base Station
serial number.
5º.-
Exit Configuration
(Unit should re-start and link with Base Station)
MS9530 Voyager RF Quick Configuration guide 3 Printed: December 2002
Version: 1.0 Status: Approved
2.- MS9530 Voyager RF ID:
- Up to five units can work together with same Base Station. It is requested that each of them
uses a different ID. Use this section to fix the desired Identifier into Voyager RF.
3.- WEDGE BASE STATION Minimum configuration: PC connection
-Please read the following barcodes in the required order:
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-
MS9530 Voyager RF Quick Configuration guide 4 Printed: December 2002
Version: 1.0 Status: Approved
3.- RS-232 BASE STATION Minimum configuration ( 9600,8,N,1, CRLF)
-Please read the following barcodes in the required order :
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Metrologic MS9530 Voyager RF Series Quick Configuration Manual

Type
Quick Configuration Manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI