Sharp NEC MultiSync WD551 User guide

NEC MultiSync WD551

Brand: Sharp

Model: NEC MultiSync WD551

Type: User guide

NEC MultiSync®WD551

Step-by-step guide

OTA firmware update

23-Jun-22

Sharp NEC Displays Solutions Europe GmbH

Firmware update via OTA (1/4)

Sharp NEC Displays Solutions Europe GmbH 2

Step 1: Connect LAN cable

1. Preparation of LAN connection

LAN cable

Step 2: Confirm LAN connection on “Advanced” – “Date & Time” of OSD

Step 2.1:

-Switch “Network Time” to disable

-Set wrong date and time to “Date”

and “Time”

Step 2.2:

-Switch “Network Time” to enable

-Check if “Date” and “Time” is

showing correct date and time

Firmware update via OTA (2/4)

Sharp NEC Displays Solutions Europe GmbH 3

Wait until the “Update” button on “Advanced” -“Firmware” -

“Firmware Update” of OSD is activated and then touch

“Update” to start the firmware process.

2. Update firmware OTA Firmware update screens

Screen 1

Screen 2

Reboot

End

Firmware update via OTA (3/4)

Sharp NEC Displays Solutions Europe GmbH 4

NOTE: Due to limitation of the current firmware

“20220601_172206” all user settings are cleared. It is

therefore required to go through the initial setup again.

3. Configure initial Setup

After the update, the “initial setup” screen is displayed.

Step 1: Touch “Start”

Step 2: Select a language

Step 3: Select “WCD Mode”

Step 4: Touch “Next” Step 5: Touch “Get started”

Firmware update via OTA (4/4)

Sharp NEC Displays Solutions Europe GmbH 5

Touch “Detail” on “Advanced” -“Firmware” -“Firmware version” of OSD.

Confirm the updated firmware version.

2. Confirm the version of firmware

Actual screen of “Firmware version” after update

Sharp NEC Displays Solutions Europe GmbH

1
2
3
4
5
6

Sharp NEC MultiSync WD551 User guide

NEC MultiSync WD551

Brand: Sharp

Model: NEC MultiSync WD551

Type: User guide

Related papers

Sharp XL-BD601PH User manual

Other documents