2. Durabook
  3. U11I
U11I

Durabook U11I User manual

  • Hello! I've reviewed the user manual for the DURABOOK U11I Folio Case. This document guides you through the installation process, covering steps from removing initial components to securing the case with screws and velcro straps. I'm ready to answer any questions you have about installing the folio case.
  • What should I do if any of the package contents are damaged?
    How do I start installing the folio case?
    What are the steps after removing the bumpers?
©2021 Twinhead International Corp and/or its affiliates. All rights reserved.
1
U11I Rugged Tablet
Folio Case
P/N: 62+009682+00
Folio Case
2
Package Contents
If any of following items is damaged, please contact your retailer.
Folio case
Bracket (4)
Screw (8)
NOTE
The pictures are for reference only, actual items may slightly differ.
Folio Case
3
Installation
This section will guide you on how to install the folio case of your tablet.
Installing the Folio Case
To install the folio case, follow the steps below:
1. Remove the 2 thread bushings (A) at the bottom of the device.
2. Remove the screws of the bumpers; there are 8 screws in total.
3. Remove the 4 bumpers by moving them to the side.
Folio Case
4
4. Install the brackets (B) as shown in the images.
5. Mount on the bracket with 2 small screws in place. Please repeat this
procedure for the other bumpers.
6. Install back the 4 bumpers.
7. Fix the bumper with 2 small screws. Please repeat this procedure for the
other bumpers.
Folio Case
5
8. Place the tablet horizontally and align the thread bushing downwards to the
positioning pins of the leather case.
9. Tear off the Velcro strap and put the steel loop in place.
10. Buckle the steel loop (C) to the strap bracket. Please repeat this procedure
on the other side.
Folio Case
6
11. Tighten the Velcro straps on both sides.
Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.
/