Home » ExBrite » ExBrite JTJSBM4836DKSXBLX LED Mirror Instructions

JTJSBM4836DKSXBLX LED Mirror

Instructions

ExBrite JTJSBM4836DKSXBLX LED Mirror Instructions

Manuals+ — User Manuals Simplified.

Contents

1 JTJSBM4836DKSXBLX LED Mirror

7 Documents / Resources

8 Related Posts

JTJSBM4836DKSXBLX LED Mirror

WARNING AND SAFETY INSTRUCTIONS

Before assembling your LED Lighted Mirror fixture, please make sure that you carefully read through this

instruction sheet, refer back to them during installation to ensure your product is fitted safely and correctly. Keep

these instructions for future use.

WARNING Risk of Fire and Electric Shock

All fittings must be installed in accordance with current IEE wiring regulations. If indoubt, consult a qualified

electrician.

Inspect the product immediately upon receipt for the transit damage or missing parts.

Handle the product with care and protect against knocks to all sides and edges of the glass.

Ensure there are no hidden pipes or cables in the wall before drilling.

Wear suitable eye protection when drilling. Take care if drilling on tiled surfaces in case the drill slips.

CAUTION

The light source of this product is non-changeable light diodes (LED). Do not disassemble the product, as the light

diodes can cause damage to the eyes.

NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible

conditions and situations that may occur. It must be understood that common sense, caution and care are factors

that can’t be built into any product. These factors must be supplied by the person(s) caring for and operating the

Measure the distance between the holes on the hanging bar, use an electric drill and punch holes on the wall

Step 2Fix the hanging bar to the wall with screws, (Drive the expansion plug into the hole on wall. then put screw

into the expansion plug)

Step 3

If wiring installation is required, ensure that the mirror is turned off when the power supply in the house is cut off.

Then connect the power cord of the mirror and the on the wall with the terminal block .

White wire = Neutral wire, black wire = Live wire, Light green wire = Earth wire.

Do not switch on the electrical supply at the mains until the end of the installation.

Step 4 Hang the mirror with desired placement by mirror

2. Anti-fog function

Short press to turn on/off defogging

Power-off memory: When the light is turned on, the power is turned off directly, and the light will automatically

light up when the power is turned on next time. If the power is turned off when the light is off, you need to touch

the switch button to turn on the light when you turn on the power next time.

LED Mirror Power Source FAQ

Scenario 1

(Direct Wired)

This is the most common way to connect the mirror. The LED light & anti fog pad are both controlled by the built-in

touch switch on the mirror.

Scenario 3

(Wall Dimmer Switch – Not Accepted) This is a scenario that is not acceptable. There is no work around for our

mirror. Do not try this way as it will damage the LED driver.