NOBOCOOL E4E GB 750 Operating instructions

Type
Operating instructions

This manual is also suitable for

NOBO PANEL RADIATORS
SERIES '14' TYPE 'E4E GB' PANEL RADIATORS
oSix sizes 500 to 2000 watt
oElectronic Thermostatic control
oAdjustable scale 5 - 30°C.
oOn - Off switch
oOver-heat Cut-Out
oWhite paint finish RAL 9010
oClassified IP 24
oFlex connection 1.9m (RH side)
oElectronic proportional temperature regulation
oVariety of Plug-In Control options:
Series 8 'R80' plug & play technology.
Wall Bracket fixing centres
L
A 200
B 300
C 400
D 600
E 1000
Telephone: 0121 328 5671 Facsimile: 0121 327 8580 Series 14 - E4E GB - Dims. txt - 1403
E4E GB 2000
E4E GB 1500
E4E GB 1250
E4E GB 1000
E4E GB 750
E4E GB 500
1125
975
1
5
2
5
475
6
2
5
775
400
110
62
A
B
E
C D
200
L
70
D
100 Min. Clearance
70 Min. Clearance
NOBO CABLE CONTROL
CONTROL MODULE type R80 ZDC designed for use with NOBO Panel heaters using Series 8 controls.
A Control module with adjustable economy & comfort settings, suitable for dual temperature applications.
supplied with pilot wire for switching
between temperature modes.
KEY to Fig. 1.
1 – Comfort temperature adjustment control.
2 – Economy temperature adjustment control.
4 – Red Comfort mode indicator light.
5 – Green Economy mode indicator light.
6 – Amber operating indicator light.
8 – On / Off switch. l = On, 0 = Off.
OPERATING INSTRUCTIONS
Switch the heater on with switch (8).
Set required temperatures with control (1&2).
Activate remote control device.
The action of the electronic thermostat provides proportional regulation of temperature. The Amber operating
indicator light will be seen to go on and off at frequent intervals as it adjusts the amount of heat supplied to
maintain room temperature. When room temperature is more than 1°C below the thermostat set point the
heater will operate continuously but during the last one degree the operation will be proportionally reduced
until the required temperature is achieved.
When the red indicator (4) is visible the heater will operate in comfort mode and maintain the higher
temperature setting (4). When the remote control device is activated the mode of operation is changed from
comfort mode to economy mode. The red indicator will go out and the green indicator (5) will come on,
the heater then will operate in economy mode and maintain the lower setting (2).
SCHEMATIC WIRING DIAGRAM 'OPTO'
PANEL RADIATOR
E N L L
230 volt 230 volt
When the control circuit is off the heater will operate in comfort mode. POWER SUPPLY CONTROL CIRCUIT
When the control circuit is energised the heater will operate at the lower setting.
Telephone: 0121 328 5671 Facsimile: 0121 327 8580 Series 8 - ZDC. txt - 240
A
ZDC Temperature control module. 240
SP CO
NOBO CABLE CONTROL
Power: 230 - 240 volts AC
Contacts: 3 amps at 240 volts
Enclosure: Double Insulated - IP30
Dimensions: 101 x 163 x 33 mm
Mounting: Wall surface mounted
Battery: 10 months
Switch: 3 on and 3 off per day
Override: 1 or 2 hours boost
Heating 2 Zone 7 day Time Control Unit.
Designed to provide time control for two heating zones using a pilot wire sytem of control.
SCHEMATIC WIRING DIAGRAM
Each heater requires both permanent power supply and live pilot wire circuits
All wiring must comply with IEE Regulations.
Observance of clause 514-11-01 of the wiring regulations in necessary where more than one live supply is taken into an appliance.
At each heater position use of a Triple Pole Isolator or two Double Pole isolators is recommended.
Telephone: 0121 328 5671 Facsimile: 0121 327 8580 13 H27Z. txt - 2ZC.02
H27Z
  • Page 1 1
  • Page 2 2
  • Page 3 3

NOBOCOOL E4E GB 750 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI