JESOHO Screen Protector Installation guide

JESOHO Screen Protector Installation

Step 1: Use the Wet Cleaning Cloths to remove surface dust and oil stain

Step 2: Use the Wiping Cloth to remove stains and residual moisture

Step 3: Use the Dust-absorber to remove tiny particles from the surface

Step 4: Open the tempered glass film, align the screen hole and put on the film

If there is residual dust, open up the tempered glass film and remove it with the

Dust-absorber, and then re-install the tempered glass film.

JESOHO Screen Protector Installation Detailed Description

1. Looking for a clean, windless, dust-free environment to operate the film.

2. (A): Wipe the dust off of the mobile phone display with a wet tissue.

(B): Wipe the display again with a dry, dust-free cloth. Be sure to wipe the dust

off the display and there should be no dust on the display.

(C): Get the glass film, let the glass face up, the bottom surface face down, tear

the bottom down, do not let the dust enter the silicone surface of the glass film.

(D): Use the earphone hole side of the mobile phone to align the glass film and

the display screen. After aligning the hole end of the earpiece, press the

earpiece part so that it does not move the misalignment, then align the lower

end (Home button part) on the phone display, then put it down gently. From left

to right or top to bottom, scratch the surface of the glass film and wait for about

5 seconds. The glass film will automatically discharge the air, and the glass film

will be integrated with the screen of the mobile phone, so that you can feel the

same as the original display, a smoother experience.

(E): After the previous step is completed, if you find that there is little dust or

small bubbles between the screen and the glass film, first remove the glass film,

stick the dust with the dust-absorber, then repeat the (D) step, lightly pressed

the small bubbles, the problem of dust and white spots could be solved.

JESOHO

This manual is also suitable for

Download PDF