Legrand LightSaver® LCD-203 & LCO-203 Dimming Controller, Quick Start Installation guide

Legrand
Brand
Legrand
Model
LightSaver® LCD-203 & LCO-203 Dimming Controller, Quick Start
Type
Installation guide
Minimum Installation and Setup
1. Install and wire the LS-290C Photocell to the controller.
2. Install the BT-203 and controller inside the enclosure.
3.
LCD-203 only: Connect low voltage dimming ballast control
wires to the LCD-203 “D” terminals.
4. Make line voltage connections to the BT-203.
5. Connect the RJ-12 Quick Connect cable from the controller to
the BT-203. This powers up the system.
6. Wait until the display shows: The Watt Stopper. Verify that the
display shows the light level from the photocell. The default for
the minimum level is 30fc, the default maximum is 3000fc.
7. Use a light meter to read the illuminance levels at a task area
that is represenative of each channel.
8. Enter the illuminance levels into the controller and update the
photocell light level by pressing the buttons as shown below.
GENERAL SET
t
RUN SEE
q
NEXT
u
ADJUSTMENT
t
BACK SEE
q
DaylightFactor
t
EXIT ADJ
u
Range 30-3000fc
NEXT
q
Task FC1 040fc
ADJ
u
LightSaver
®
LCD-203
1.800.879.8585
7
81291011
A
A
45 781 23 129 10 116
B
B
41 2653
D
D
The Watt Stopper
0420fc
The numbers in the display indicate the current light level
(in footcandles) at the LS-290C Photocell.
Press any button to enter the programming mode.
LCD-203 and LCO-203
Daylighting Controller
Quick Start Guide
FC = 040fc
p
ADJ
FC = 082fc
t
SAVE
Task FC1 082fc
NEXT
q
FC = 040fc
p
ADJ
Photocell 0120fc
t
EXIT ADJ
u
FC = 066fc
t
SAVE
Task FC2 040fc
ADJ
u
Task FC2 066fc
NEXT
q
FC = 040fc
ADJ
q
FC = 026fc
t
SAVE
Task FC3 040fc
ADJ
u
Task FC3 026fc
NEXT
q
Copyright© 2005 Watt Stopper/Legrand 04943r1 02/2005
CAUTION
TURN THE POWER OFF AT THE CIRCUIT BREAKER
BEFORE WORKING WITH LINE VOLTAGE CONNECTIONS.
Photocell 0420fc
t
SAVE
p
ADJ
q
ESC
u
Photocell 0420fc
t
EXIT ADJ
u
t
t
t
t
Revert to previous setting.
Enter setting manually.
Current Photocell light
level reading is
enter
ed automatically.
78Y000_13_R1_050304_MS_1206
  • Page 1 1

Legrand LightSaver® LCD-203 & LCO-203 Dimming Controller, Quick Start Installation guide

Legrand
Brand
Legrand
Model
LightSaver® LCD-203 & LCO-203 Dimming Controller, Quick Start
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents