2. GW Instek
  3. GDM-8261A/8255A How to create the loading default when power on

GW Instek GDM-8261A/8255A How to create the loading default when power on User manual

  • Hello! I've reviewed the user manual for the GW Instek GDM-8261/GDM-825xA digital multimeters. This document covers how to configure the interface, save instrument settings, and recall them. It also mentions that the DMM will use saved parameters as power-on defaults. Feel free to ask me anything related to these topics or the devices themselves, and I'll do my best to assist you based on the content of the manual.
  • How do I select interface type?
    How do I save instrument settings?
    How do I recall instrument settings?
Operation Description
(USB, Save and Recall setting process)
Interface Configuration
1. Turn on the GDM-8261 /or GDM-825xA
2. Press → to get into MENU. And then press twice, go to I/O
section.
3. Press for interface selection (select RS232 or USB by press )
4. Press and for interface configuration, then press to confirm
the changing. (Note: the interface configuration is complete)
Save instrument
5. Press to go back to I/O section. And then press twice, to go back to
SYSTEM section.
6. Press , then press twice to go to SAVE section.
7. Press to save the instrument current condition into the PARA:01 (PS. To save
other PARA address, please using ), then press to confirm the setting.
(Note: the save instrument is complete)
Recall instrument
8. Press to go to RECALL section.
9. Press to recall the instrument condition into the PARA:01 (PS. To recall other
PARA address, please using ), then press to confirm the setting.
(Note: the recall instrument is complete)
10. Press to leave the MENU setting condition.
Notice 1：Since the above process is complete, the DMM is always running PARA:01 as
a power-on default instead of factory default.
Notice 2：While saving the instrument parameter, the current Function/Range of DMM
is also included, but not including the scanner channel condition.
/