Neutrik NC3MX-TOP + NC5MX-TOP Assembly Instruction

Brand: Neutrik

Model: NC3MX-TOP + NC5MX-TOP

Type: Assembly Instruction

ASSEMBLY INSTRUCTION

NC3MX-TOP & NC5MX-TOP |XLR Cable Connector

1STANDARD CABLE ASSEMBLY

45°

Cut cable end approx. 45°.

Slide the bushing over the cable.

To ease the boot assembly apply some

cable pulling lubricant to the cable ends.

1STANDARD CABLE ASSEMBLY

2CABLE & BOOT ASSEMBLY WITH INSERTION TOOL

Position Insertion Tool ontothe the

cable.

Wet the tip with mounting fluid.

Page 1BDA 550 V3

13& STANDARD ASSEMBLY OF XLR CONNECTOR

23& WITH ASSESSORIES:

CABLE & BOOT ASSEMBLY WITH INSERTION TOOL.

ITX-TOP: Cable insertion tool to guide the cable into the boot.

PIP65 RATED AND TOP-APPROVED.

!MOUNTING VERSIONS

XLR TOP NC3MX-TOP & NC5MX-TOP

Slide the cable with the tool throught the

boot.

Remove the tool.

3ASSEMBLY INSERT AND CONNECTOR

Page 2BDA 550 V3

SOLDER

Prepare cable as shown.

Insert wires into the terminals and SOLDER

them.

Wiring 3 pole 5 pole:

Put chuck onto the cable.

Attention: Pay attention to the guiding key.

Slide insert and chuck together into the

housing.

Important:

Align the insert by positioning as shown.

Cable O.D. - 8.0 mm: 5.0

[0.19 - 0.32”]

Cable O.D. - 8.0 mm: 5.0

[0.19 - 0.32”] 18 [0.71”]

4 [0.16”]

Page 3

EFinish the installation by turning the bushing

onto the connector.

Attention:

Screw the bushing to the end of the thread.

PFINISHED XLR TOP

www.neutrik.com

Draft. Nr.: BDA 550 V3

Update: 2023-03-21

Neutrik AG LI-9494 Schaan

A brand of the Neutrik Group

Find more XLT TOP

details on

www.neutrik.com.

ITX-TOP TOOL:

Find more details on

www.neutrik.com/product/

itx-top

FINISHED XLR CONNECTOR

iMore Information on the website

XLR TOP NC3MX-TOP & NC5MX-TOP

Neutrik NC3MX-TOP + NC5MX-TOP Assembly Instruction

Neutrik NC3MX-TOP + NC5MX-TOP Assembly Instruction

Neutrik NC3MX-TOP + NC5MX-TOP Assembly Instruction

Related papers

Other documents