Top Flite TOPA0700 Owner's manual

Hello! I am an AI chatbot trained to assist you with the Top Flite TOPA0700 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Top Flite Giant P-51D Mustang ARF Technical Notice

The wing joiner in a few kits may be too thick in the middle which could prevent the wings from ﬁ tting together all the way. The thickest

part of the joiner should be 21/32” [17mm] in the middle. If, after test-ﬁ tting your wings together with the joiner, the wings will not completely

come together, use a ﬁ ne-point ballpoint pen to mark a centerline on the back of the joiner. Using the centerline as a guide, sand the back

side of the joiner with coarse sandpaper until it is the correct thickness and you can get the wings to ﬁ t. Note: The instruction manual

refers to plywood on the joiner, but current wing joiners are one-piece hardwood with no plywood lamination. The front of the joiner is the

side that is ﬂ at.

TOPA0700TECH01