Maytronics dolphin dx6 User Instructions

  • Hello! I am an AI chatbot trained to assist you with the Maytronics dolphin dx6 User Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
USER INSTRUCTIONS
DOLPHIN DX6
1333 Rymal Road E. Hamilton, Ontario L8W 3N1
Phone: 905-388-5391 Fax: 905-388-3764
Email: [email protected] Website: www.thepoolshoppe.ca
User Instructions
1
What You’ll Find Inside the Box
1
2
2
User Instructions
3
4
5
6
7
8
9
3
User Instructions
10
0
11
12
13
14
15
0
16
4
User Instructions
17
18
19
20
21
Maytronics Remote Control Unit
The Remote Control Unit (RCU) offers two operation modes- Automatic mode and Manual direction control
mode. In Automatic mode, all cleaning parameters can be changed. In Manual direction mode, the Pool Cleaner
direction can be controlled manually.
User Instructions
Maytronics Remote Control Unit
Setting the Automatic Mode
Cleaning cycle indicator
This determines the cleaning
cycle time. The RCU allows
you to choose between the
following options.
Fast
2 hour cycle
Efficient
(Default Setting)
3 hour cycle for
everyday use
Extra
4 hour cycle
Delay Time indicator
This determines when the
pool cleaner starts to work. A
delay allows the dirt to settle
to the bottom of the pool.
Immediate start
(Default Setting)
1 hour delay
2 hour delay
Cleaning action indicator
Allowing you to choose from
the following options.
Standard
Floor and wall cleaning
(Default Setting)
Ultra-Clean
Stronger suction and
slower movement.
Floor Only
Cleans only the
floor and coves.
Walls Only
Cleans walls and
waterline only
6
User Instructions
To Change the Automatic Mode settings
First press the Manual/Automatic select button, then set according to the following table:
Note:
After 2 minutes, if no button is pressed, the Remote Control Unit will shut-down and the Pool cleaner will continue to work
in the previous settings.
When the “Ultra-Clean,” and “Walls Only” options finish their cycles, the RCU will return to default settings.
User Instructions
7
/