BEA LO-LINX User manual

Type
User manual

This manual is also suitable for

BEA LO-LINX

  • LO-LINX is a 24V transformer that features a pre-wired switch assembly and comes with a BODYGUARD (Y) HARNESS used for dual-egress applications.
  • It includes sensors for safety and activation and can be connected to a variety of door and gate operators, including those from Besam, Horton, Hunter, Stanley, and Tormax.
  • The LO-LINX also has an AUX input that can be used to connect a knowing act switch, such as a pushplate or card reader.
  • This input is required for all initial activation when the function 'FA' on the LO-LINX is set to '01'.

BEA LO-LINX

  • LO-LINX is a 24V transformer that features a pre-wired switch assembly and comes with a BODYGUARD (Y) HARNESS used for dual-egress applications.
  • It includes sensors for safety and activation and can be connected to a variety of door and gate operators, including those from Besam, Horton, Hunter, Stanley, and Tormax.
  • The LO-LINX also has an AUX input that can be used to connect a knowing act switch, such as a pushplate or card reader.
  • This input is required for all initial activation when the function 'FA' on the LO-LINX is set to '01'.
NOTES: 1) BEA RECOMMENDS TO USE THE HUNTER SYNC BOARD TO SYNC 2 DOOR CONTROLS WITH A PAIR OF DOORS.
2) IF USING AN OPTIONAL INHIBIT SWITCH FOR THE SAFETY SIDE SUPERSCAN. ROUTE THE INHIBIT SWITCH N.C. CONTACT TO STALL 1 &/OR 2.
IF AFTER TROUBLESHOOTING A PROBLEM, A SATISFACTORY SOLUTION CANNOT BE ACHIEVED, PLEASE CALL B.E.A., INC.
FOR FURTHER ASSISTANCE DURING EASTERN STANDARD TIME AT 1-800-523-2462 FROM 8AM - 5PM. FOR AFTER-HOURS,
CALL EAST COAST: 1-866-836-1863 OR 1-800-407-4545 / MID-WEST: 1-888-308-8843 / WEST COAST: 1-888-419-2564. DO NOT
LEAVE ANY PROBLEM UNRESOLVED. IF YOU MUST WAIT FOR THE FOLLOWING WORKDAY TO CALL B.E.A., LEAVE THE
DOOR INOPERABLE UNTIL SATISFACTORY REPAIRS CAN BE MADE. NEVER SACRIFICE THE SAFE OPERATION OF THE
AUTOMATIC DOOR OR GATE FOR AN INCOMPLETE SOLUTION.WEB: WWW.BEASENSORS.COM
Pre-wired
switch
assembly
HOLD OPEN
OFF
AUTO
LO-LINX
SETUP
PWR
TO CTRL
BEAM
TX RX
SWITCH
AUXSENSORSMTR STALL
ACTIVATION SUPERSCAN
SAFETY SUPERSCAN
EAGLE 1
EAGLE 2
MOTOR
-
+
24 V
TRANSFORMER
RED
RED
BROWN
WHITE
BLUE
YELLOW
GREEN
ACTIVATION SUPERSCAN
SAFETY SUPERSCAN
BODYGUARD
BODYGUARD 2
BLACK
RED
RED
BLACK
WHITE
BODYGUARD (Y) HARNESS
USED FOR DUAL-EGRESS
APPLICATIONS
SIZE:
DRAWN BY:
TITLE: Hunter FA Control,LO-LINX
A
100 ENTERPRISE DRIVE
PITTSBURGH, PA 15275
PHONE: (412) 249-4100
FAX: (412) 249-4101
EMAIL: www.beasensors.com
REV BY:
80.0272.01
SCALE:
DATE:
NONE
05/17/2007
PART NO:
SHEET
1 OF 1
JED TUC
IF AFTER TROUBLESHOOTING A PROBLEM, A SATISFACTORY SOLUTION CANNOT BE ACHIEVED, PLEASE CALL B.E.A., INC. FOR FURTHER ASSISTANCE
DURING EASTERN STANDARD TIME AT 1-800-523-2462 FROM 8AM - 5PM. FOR AFTER-HOURS, CALL EAST COAST: 1-866-836-1863 OR 1-800-407-4545 /
MID-WEST: 1-888-308-8843 / WEST COAST: 1-888-419-2564. DO NOT LEAVE ANY PROBLEM UNRESOLVED. IF YOU MUST WAIT FOR THE FOLLOWING
WORKDAY TO CALL B.E.A., LEAVE THE DOOR INOPERABLE UNTIL SATISFACTORY REPAIRS CAN BE MADE. NEVER SACRIFICE THE SAFE OPERATION
OF THE AUTOMATIC DOOR OR GATE FOR AN INCOMPLETE SOLUTION.WEB: WWW.BEASENSORS.COM
SIZE:
DRAWN BY:
TITLE: HUNTER LO-LINX SYSTEM
A
100 ENTERPRISE DRIVE
PITTSBURGH, PA 15275
PHONE: (412) 249-4100
FAX: (412) 249-4101
EMAIL: www.beasensors.com
REV BY:
80.0285.00
SCALE:
DATE:
NONE
10/15/2007
PART NO:
SHEET
1 OF 1
JED TUC
NOTES:
1. MOTOR CONNECTION IS TIED IN PARALLEL TO EXISTING MOTOR LEADS. NO RESPECT TO PALARITY IS REQUIRED.
2. EXTERNAL SWITCHES ARE REQUIRED IF INHIBIT DESIRED AT SWING SIDE SUPERSCANS, SWITCH OPENS UPON INHIBIT POINT.
3. THE KNOWING ACT SWITCH IS CONNECTED AT THE AUX INPUT AND CAN BE ANY DRY CONTACT DEVICE SUCH AS A PUSHPLATE, CARD READER,
ETC. THE AUX INPUT IS REQUIRED FOR ALL INITIAL ACTIVATION WHEN FUNCTION 'FA' ON THE LO-LINX IS SET TO '01'.
4. THE SECOND BODYGUARD AND EAGLE ARE PRIMARILY USED IN DUAL-EGRESS APPLICATIONS. ENSURE BODYGUARD RELAY VALUE IS SET TO 2.
5. BEA RECOMMENDS TO USE THE HUNTER SYNC BOARD TO SYNC 2 DOOR CONTROLS FOR A PAIR OR DOUBLE EGREES SET OF DOORS.
BROWN
WHITE
BLUE
YELLOW
GREEN
Pre-wired
switch
assembly
DC
MOTOR
-
+
RED
RED
BLACK
RED
BODYGUARD (Y) HARNESS
USED FOR DUAL-EGRESS
APPLICATIONS
*
LO-LINX SUPERSCAN HARNESS
p/n: 70.5071
LO-LINX EAGLE HARNESS p/n: 20.5096
LO-LINX BODYGUARD
HARNESS p/n: 20.5082
LO-LINX POWER
HARNESS p/n: 20.5095
LO-LINX SWITCH HARNESS p/n: 20.5078
LO-LINX CONTROL
HARNESS p/n: 20.5097
24 V
TRANSFORMER
HOLD OPEN
OFF
AUTO
RED
BLACK
WHITE
LO-LINX MOTOR HARNESS p/n: 20.5076
75.5137.02
LO-LINX
SETUP
INCR.
FUNCT.
12-24V
AC/DC
PWR
TO CTRL
STALL
SAFETY
ACTIV.
STALL COM
SFTY / ACT COM
BEAM
TX RX
SWITCH
GND
AUTO
HOLD
AUX
COM
N/O
EAGLE 1
EAGLE 2
BODY-
GUARD
SENSORS
DOOR MTD
SENSOR 1
DOOR MTD
SENSOR 2
MTR
MOTOR
STALL 1
STALL
STALL 2
E
M
P
T
Y
1
I
N
H
I
B
I
T
G
N
D
2
I
N
H
I
B
I
T
+
3
N
.
C
.
4
N
.
O
.
5
C
O
M
6
P
O
W
E
R
7
P
O
W
E
R
8
E
M
P
T
Y
1
I
N
H
I
B
I
T
G
N
D
2
I
N
H
I
B
I
T
+
3
N
.
C
.
4
N
.
O
.
5
C
O
M
6
P
O
W
E
R
7
P
O
W
E
R
8
RED
BLACK
WHITE
GREEN
RED
BLACK
WHITE
GREEN
DOOR MTD SENSOR
APPROACH SIDE
DOOR MTD SENSOR
SAFETY SIDE
E
M
P
T
Y
1
I
N
H
I
B
I
T
G
N
D
2
I
N
H
I
B
I
T
+
3
N
.
C
.
4
N
.
O
.
5
C
O
M
6
P
O
W
E
R
7
P
O
W
E
R
8
E
M
P
T
Y
1
I
N
H
I
B
I
T
G
N
D
2
I
N
H
I
B
I
T
+
3
N
.
C
.
4
N
.
O
.
5
C
O
M
6
P
O
W
E
R
7
P
O
W
E
R
8
RED
BLACK
WHITE
GREEN
RED
BLACK
WHITE
GREEN
DOOR MTD SENSOR
APPROACH SIDE
DOOR MTD SENSOR
SAFETY SIDE
GREEN
WHITE
BLACK
RED
EAGLE 1
GREEN
WHITE
BLACK
RED
EAGLE 2
RED
BLACK
WHITE
BROWN
BLUE
GREEN
RED
BLACK
WHITE
BROWN
BLUE
GREEN
SEE NOTE # 4
SEE NOTE # 4
SEE NOTE
#2
SEE NOTE #1
LO-LINX GREEN WHITE
Y
ELLO
W
BLUE BROWN
SWING ACT.COM.SAF.STALLSTAL COM.
B E S A M 3 0 0 13 12 11 15 , 17 16 , 18
BESAM M/P 3 4 9 5 13
DOM YELLOW GREY BLUE PURPLE GREY
GT 300/400 BLACK RED WHITE WHITE RED
GT MAG 6 BLACK 5 RED 4 WHITE 3 VIOLET 5 RED
HORTON 4190 2 3, 6, 8 4 10 3, 6, 8
HUNTER ACT. RTN SAF. 1 SAF. 2 RTN
KM K GREEN WHITE RED YELLOW WHITE
STANLEY "L" ORANGE YELLOW RED BLUE YELLOW
STANLEY M /P 2 1, 8 7 7 1, 8
STANLEY 521 TB4-5 TB4-4 TB4-8 TB4-10 TB4-9
TORMAX TDA 2 1 ,3, 6, 8 8 & 9 7 1, 3, 6, 8
COM
N/O
SEE NOTE #3
SEE NOTE # 4
  • Page 1 1
  • Page 2 2

BEA LO-LINX User manual

Type
User manual
This manual is also suitable for

BEA LO-LINX

  • LO-LINX is a 24V transformer that features a pre-wired switch assembly and comes with a BODYGUARD (Y) HARNESS used for dual-egress applications.
  • It includes sensors for safety and activation and can be connected to a variety of door and gate operators, including those from Besam, Horton, Hunter, Stanley, and Tormax.
  • The LO-LINX also has an AUX input that can be used to connect a knowing act switch, such as a pushplate or card reader.
  • This input is required for all initial activation when the function 'FA' on the LO-LINX is set to '01'.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages