Form No. 107101
Operating Instructions
for: 6477
(511545)
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7290
Fax: (507) 455-7063
© Bosch Automotive Service Solutions LLC
July 25, 2014 Rev. C
Ford Camshaft Holding Tool
Application: 1997 – 2009 4.6L Econoline, F-Series Truck (VIN W)
1997 – 2002 5.4L Econoline (V8), Expedition, F-Series Truck
1997 – 2002 6.8L V10 Econoline
1998 – 2002 5.4L V8 Navigator
1. Install tool No. 6477 (511545) on the camshaft as
shown.
2. Torquehexhd.boltsat20ft.•lbs.toensurecorrect
clamping force. Note: Each bolt must be engaged by
the same number of threads in the bottom clamp to
ensure correct clamp alignment.
3. Repair the engine as required according to instructions
in the vehicle service manual.
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
No. 6477
(511545) NOTE:
• Same as Ford No. 303-557 (T96T-6256-B)
• This tool is used with No. 6476 (511543 & 511544) Ford
Camshaft Positioning Tool Set.
Form No. 107101
Operating Instructions
for: 6477
(511545)
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7290
Fax: (507) 455-7063
© Bosch Automotive Service Solutions LLC
July 25, 2014 Rev. C
Ford Camshaft Holding Tool
Application: 1997 – 2009 4.6L Econoline, F-Series Truck (VIN W)
1997 – 2002 5.4L Econoline (V8), Expedition, F-Series Truck
1997 – 2002 6.8L V10 Econoline
1998 – 2002 5.4L V8 Navigator
WARNING: Wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
No. 6477
(511545)
1. Install tool No. 6477 (511545) on the camshaft as
shown.
2. Torquehexhd.boltsat20ft.•lbs.toensurecorrect
clamping force. Note: Each bolt must be engaged by
the same number of threads in the bottom clamp to
ensure correct clamp alignment.
3. Repair the engine as required according to instructions
in the vehicle service manual.
NOTE:
• Same as Ford No. 303-557 (T96T-6256-B)
• This tool is used with No. 6476 (511543 & 511544) Ford
Camshaft Positioning Tool Set.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
OTC 6489 Operating instructions
-
-
-
-
-
-
-
-
OTC 6024 User manual
-