DMX512 0-10V/PWM Dimmer 70060016
L
N
N’
L’
GND
0
5VDC
GND
0-10V
0
15VDC
0-10V
AC
INPUT
AC
OUTPUT
0
15VDC
0
5VDC
OUTPUT 1 OUTPUT 2
DMX512 (0-10V/PWM)
Controller
Operation
D1-
D1+
D2-
D2+
DMX512 SIGNAL
GND
Set DMX address
Press and hold down 1st button for 2 seconds, digital display flashes to set the
required DMX address, then press and hold down any button for >2 seconds to
confirm.
Through buttons to set desired DMX512 address, button 1 is to set “hundreds”
position, 2 is to set “tens” position, 3 is to set “unit” position.
“1" button
“2" button
“3" button
DMX512 Master
Manual set button:
can set the DMX address
and DMX channel
Function introduction
Important: Read All Instructions Prior to Installation
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
2x(0-10VDC)/2x(0-15VDC)/
2x(0-5VDC) output
Product Data
Safety & Warnings
2 groups DMX512 signal
input & output
AC Power
50/60Hz
Wiring Diagram
V+
V-
DIM+
DIM-
ACN
ACL
0-10V/PWM Dimmable
Power Supply
V+
V-
DIM+
DIM-
ACN
ACL
0-10V/PWM Dimmable
Power Supply
V+ V+
V- V-
V+ V+
V- V-
Mono LED Strip
Mono LED Strip
0-5 0-9 0-9
Digital display
• Receives DMX512 signal, 2 channels 0-5V/0-10V/0-15V signal output
• Compatible with different DMX512 controls
• To dim and switch Single color LED lighting.
• Waterproof grade: IP20
L
N
N’
L’
GND
0
5VD C
GND
0-1 0V
0
15V DC
0-1 0V
AC
INP UT
AC
OUT PUT
0
15V DC
0
5VD C
OUT PUT 1 OUT PUT 2
DMX512 (0-10V/P WM )
Controller
D1-
D1+
D2-
D2+
DMX 512 SIG NAL
GND
0-5 0 -9 0- 9
Input
Voltage
Input
Current
100-240VAC 2x(0-5VDC)/2x(0-10VDC)/2x(0-15VDC)
60mA max
Output Power Size(LxWxH)
170x59x29mm
Output
Current
20mA max
Product Dimension
Choose DMX Channel
Press and hold down 2nd and 3rd buttons simultaneously for 2 seconds, cH digital
display flashes, then click 1st button to choose 1/2, 1 means total 1 channel, 2
means total 2 channels. Press and hold down any button for >2 seconds to confirm
the 1 or 2 channels. The factory default is 2 channels.
NOTE:
For example, when we set address to 001.
When select 1cH, all two output channels will be the same address 001 and controlled simultaneously.
When select 2cH, the two output channels will be address 001, 002 respectively and controlled separately.
AC100-240V
input & output
Relay output:
max. 5 Amps
170 mm
59 mm29 mm
/
