2. Siemens
  3. Cerberus Pyrotronics CXL-UK Kit

Siemens Cerberus Pyrotronics CXL-UK Kit User manual

  • Hello! I've reviewed the installation instructions for the Siemens CXL-UK Kit, designed for upgrading CERBERUS PYROTRONICS CXL software. The document details the necessary hardware installations (IC18, IC19, IC22 and IC5) and verifications for a successful upgrade to Rev 8.0. I'm here to help if you have any questions about this process or the hardware involved.
  • What is the first step in upgrading the CXL software?
    What components should be present and verified before installation?
    Which components should be installed during the upgrade?
    In what order should power be restored after the installation?
Installation Instructions
CERBERUS PYROTRONICSTM
Model CXL-UK Kit
CXL Software Rev 8.0
P/N 315-091782-4
Cerberus Division
Siemens Building Technologies, Inc.
8 Fernwood Road
Florham Park, New Jersey 07932
Siemens Building Technologies, Ltd.
50 East Pearce Street
Richmond Hill, Ontario L4B 1B7 CN
2. Verify that IC1, IC2, and IC3 are present and
that the switches are set as shown.
3. When the installation is complete, connect the
AC power first and then the battery to the
CXL system.
INSTALLATION
(Refer to WIRING below)
To upgrade CERBERUS PYROTRONICSTM
CXL software to Rev 8.0 or greater:
Remove all system power before installa-
tion, first the battery and then AC.
1. Install IC18, IC19, IC22, and IC5 as shown
below. Note that IC19 is new effective
with Rev. 8.0.
firealarmresources.com
/