User Manual
USER MANUAL Model No: 3386
Wallpaper Stripper
This product is not a toy, and is only to be used for its designated purpose.
Never carry out any alterations or modifications to this product.
This product is intended for indoor use only.
Ensure the power supply to the socket into which the appliance is plugged, is in
accordance with the rating label on the appliance and that the socket is earthed.
This product is not intended for use by persons (including children) with reduced
physical, sensory, and mental capacities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
product by persons responsible for their safety.
Never leave the product unattended whilst it is switched on. If you have to leave
the product, unattended, even for a short while, always switch it off.
The product is only intended for domestic use and only in the manner described
in this instruction manual.
Do not place the mains lead on or near any hot surface.
Do not touch the product if your hands are moist or wet.
Do not attempt to unplug the product by pulling on the power cord.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product. Make sure the product is
off, unplugged from the socket and been left for five minutes to remove the risk
of electrical shock.
If the product is damaged or has any defects, please contact cs[email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3386
USER MANUAL Model No: 3386
Operating Instructions
Parts List:
If you are missing any of the below parts please contact c[email protected]
1 x 4.5L Water Tank
1 x Steam Pad
1 x 3m Hose
1 x BS Certified Plug & Power Cord
*Note: When unpacking the wallpaper stripper, you will notice a small black part attached
to where the tank and hose connect. This can simply be removed, as it’s purpose is to
prevent anything entering the tank during manufacturing and transit.
How to Use:
1. Attach the steam pad to the 3m hose, ensuring that they are secured together correctly.
2. Attach the 3m hose to the lid of the 4.5L water tank.
3. Remove the lid from the water tank and fill the water tank to its limit (4.5L). Once done,
ensure that the lid is secured correctly onto the water tank.
4. Place the power cord into the back of the water tank lid, ensuring it is inserted correctly.
After this, plug it into an earthed wall socket.
5. Turning the knob dictates how much steam is allow through, use this to moderate usage.
The stripper has an automatically controlled temperature system so steam production is
kept constant, but avoids overheating.
Environmental Protection
Products bearing the symbol shown below means that used electrical and electronic equipment (WEEE) should not be mixed with general
household waste. For proper treatment, recovery and recycling, please take this product(s) to designated collection points where it will be
accepted free of charge. Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on
human health and the environment, which could otherwise arise from inappropriate waste handling. Please contact your local authority for
further details of your nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with
your national legislation.
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 3386
/
