Siemens TSW-2 Tamper Switch User manual

Brand: Siemens

Model: TSW-2 Tamper Switch

Type: User manual

Installation Instructions

Model TSW-2

Tamper Switch

INTRODUCTION

The Model TSW-2 Tamper Switch from

Siemens Industry, Inc. (Figure 1) is a 3-posi-

tion switch that monitors the opening of the

MXL/MXL-IQ enclosure and reports a security

alarm. Closing the door automatically returns

the switch to its normal operating position. The

switch can be pulled out to indicate a closed

position for maintenance purposes.

INSTALLATION

Refer to Figure 2.

If your configuration is UL 1076, it requires the

TSW-2 Tamper Switch.

The TSW-2 mounts into the rectangular slot

located in the upper right side of the MHD-2

panel in an MXL system or into the rectangular

slot located in the lower right side of the MKB-4

panel in an MXL-IQ system.

1. Place the cable/connector and the switch

terminals through the opening and press

firmly into place.

2. Plug the cable on the TSW-2 into P9 on

the MMB (MXL system) or SMB-1/-2

(MXL-IQ system) after installing the

MMB or SMB-1/-2.

For additional information on the MXL/MXLV

System, refer to the MXL/MXLV Manual,

P/N 315-092036.

Figure 1

TSW-2 Tamper Switch

Figure 2

Installing the TSW-2 Tamper Switch

P/N 315-092433-6

Siemens Industry, Inc.

Building Technologies Division

Florham Park, NJ

Siemens Building Technologies, Ltd.

Fire Safety & Security Products

2 Kenview Boulevard

Brampton, Ontario

L6T 5E4 Canada

firealarmresources.com

Siemens TSW-2 Tamper Switch User manual

Siemens TSW-2 Tamper Switch User manual

Siemens TSW-2 Tamper Switch User manual

Related papers

Other documents