Flashforge Guider IIs Assembly Instruction Manual

  • Hello! I am an AI chatbot trained to assist you with the Flashforge Guider IIs Assembly Instruction Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How do I replace the high-temperature extruder on my Flashforge Guider 2/2s 3D printer?
    What are the steps involved in replacing the high-temperature extruder?
    What tools do I need to replace the high-temperature extruder?
    Where can I find more information on replacing the high-temperature extruder?
This guide is only applicable to FLASHFORGE Guider2/2s 3D printer
Replacement of
High-temperature
Extruder for Guider II/ IIs
Tel: +86 579 82273989 Web: www.flashforge.com Add: 2/F, No.518, Xianyuan Road, Jinhua, Zhejiang, China
After-Sales Service: [email protected] Amazon.com orders only: [email protected]
Scan RQ code to watch Replacement of High-temperature Extruder video.
https://youtu.be/y285mWS104E
01
Kit Contents
High-temperature Extruder x 1Air Guide x 1
Remove the three screws fixed the top
cover of extruder by using 2.5mm
Allen Wrench, Remove the top cover of
extruder.
* In case cable is brokening,hold cable
when remove the top cover.
Power down before replace
high-temperature nozzle.
WARNING
Top Cover of
Extruder
02
Cable
Step 1
Air Guide
03
Remove the two screws fixed the Air
Guide by using cross screwdriver,
Remove the air guide.
Step 2
Screws Screws
ServoServoServo
HeatingHeating
TubeTube
Heating
Tube
3
5
1. Unplug the blue thermocouple. (
2. Loss the two screws xed the heating
tube nest by using straight screwdriver
and unplug heating tube nest.③)
3. Remove the two screws fixed the leveling
servo by using cross screwdriver, and remove
the servo. (⑤
4. Unplug the nest of leveling servo. (④、①
5
Servo
Screw
Servo Nest
Heating Tube
1
2
3
4
Blue
Thermocouple
Heating Tube
04
Step 3
05
Loose the screw hided in the back of PCB
board by using 2.0mm Allen Wrench.
Remove the nozzle assembly.
Air GuideAir GuideAir Guide
Step 4 Step 5
High-temperature High-temperature
ExtruderExtruder
High-temperature
Extruder
Air Guide
06
Install red air guide assembly and fixed it
by cross screwdriver.
Install High-temperature Nozzle Assembly.
Step 6 Step 7
07
Tighten the screw hide in the back of PCB
board by using 2.0mm Allen Wrench.
Fixed the two screws of leveling servo
by using cross screwdriver.
Step 8 Step 9
ServoServoServo
08
1. Plug back the nest of servo. (④、①)
2. Plug the blue thermocouple. (②)
3. Plug two heat tube nest and fixed by
using straight screwdriver. (③)
Step 10
HeatingHeating
TubeTube
Heating
Tube
3
Servo Nest
1
2Blue
Thermocouple
Heating Tube
3
4
Heating Tube
Cable
Top Cover
09
Cover up the extruder top
coverFixed the top cover by
using 2.5mm Allen Wrench.
Finished
Step 11
/